深冲板St15再结晶退火过程织构演变的试验研究-中国科技论文在线.PDFVIP

____________________________________________________________________________ 深冲板 St15 再结晶退火过程织构演变的实验研究 孙景宏1) 1) 1) 1) 2) 2) 刘雅政 周乐育 屠永刚 佟强 郭燕昌 1）北京科技大学材料科学与工程学院，北京 100083 2 ）本溪钢铁（集团）公司技术中心，本溪 117000 摘 要 运用电子背散射花样技术 （EBSP ）对本钢深冲板 St15 再结晶退火过程中的织构演变规律进行 了研究。当加热速度为 30℃/h 时，深冲板 St15 再结晶开始温度在 560℃左右，再结晶完成时间约为 2 小时，最强织构组分为{100}110 。随着温度的升高，深冲板 St15 的γ纤维织构，尤其是{111}112 织构有所增强。当保温温度是 700℃，随保温时间延长，深冲板 St15 的{111}110织构明显增强，4h 后{111}112织构开始逐渐增强，到 13h 时，获得理想的退火织构。 关键词 EBSP ；深冲板；再结晶退火；织构 分类号 TG142.1 Experiment Investigation of Texture Evolution during Recrystallizaiton Annealing of Deep-Drawing Sheet St15 1) 1) 1) 1) 2) 2) SUN Jinghong , LIU Yazheng , ZHOU Leyu , TU Yonggang , TONG Qiang , GUO Yanchang 1) Materials Science and Engineering School, University of Science and Technology Beijing, Beij ing 100083, China 2) Benxi Iron Steel (Group) Co Ltd, Benxi 117000, China ABSTRACT Electrical back scatter pattern (EBSP) is used to investigate texture evolution rule during recrystallization annealing of deep-drawing sheet St15 of Benxi’ Steel. When the heating rate is 30 ℃/h, the recrystallization temperature of deep-drawing sheet St15 is about 560℃, and the recrystallization finishing time is nearly 2 hours. The strongest texture component of recrystallization texture is {100}110. γ fibre texture of St15, especially {111}112, enhances along with the heightening of the annealing temperature. When holding temperature is 700℃, {111}110 texture of St15 enhances along with the extending of the annealing time. {111}112 texture gradually enhance after holding temperature for 4h. When holding te