电流传感器的高频响应特性分析电气工程专业论文.docxVIP

AbstractAbstract Abstract Abstract At present，the analysis of the current sensor is based on lumped parameter model，however,when the high frequency signal transmits，if the actual dimension of the circuit dimensions is near to the operating wavelength，the lumped parameter model cannot used，we should consider the propagation of electromagnetic waves，and analyze the problem based on distribution parameters model． On the basis of distributed parameter model and calculation formulas． transfer impedance of Rogowsk coi l is figured out when transmission of electromagnetic wave in Rogowsk coil at high frequency is taken into account． Factors which influence the characteristic of the transfer impedance of the coil under high frequency include not only the turns of the coil，but also the length of output cable，the parasitic inductance of integrating resistor，as well as magnetic core itself,which are studied by both simulation and experiments．All these provide theory guidance to the design of sensors． The results of simulation and experiments show that a series of zeros exist in high frequency section of the amplitude frequency response curve，the frequency of these zeros decreases with the increasing of the turns of the coil， but the amplitude frequency response curve dosen’t decrease with the increasing of frequency．When the end of the output cable does not match，it will cause the periodic oscillation changes of the amplitude-frequency characteristic curve，and the cycle is inversely proportional to the length of the cable．When the end of the output cable match，the oscillation caused by the output cable can be eliminated． So the 50 ohm resistance should be matched at the end of the output cable in the experiment．When considering the inductance of the integral resistance， oscillation will exist in high frequency section of the amplitude frequency response curve，the oscillation increases with the increasing of frequency,SO the II 万方数据 Abstractinductance Abstract inductance of th