内嵌式碳纤维板条与混凝土粘结性能的拉拔试验-中南大学学报.PDF

第 38 卷第 2 期 中南大学学报( 自然科学版) Vol.38 No.2 2007 年 4 月 J. Cent. South Univ. (Science and Technology) Apr. 2007 内嵌式碳纤维板条与混凝土粘结性能的拉拔实验 周朝阳，胡志海，贺学军，李 蓓 ( 中南大学 土木建筑学院，湖南 长沙，410075) 摘 要：采用新型的 C 型试块进行直接拉拔实验，研究碳纤维板条粘结长度、混凝土强度等级和嵌槽尺寸对界面 粘结性能(包括破坏形式) 的影响。研究表明：极限载荷随粘结长度、混凝土的强度等级和嵌槽尺寸的增大而增大， 其中粘结长度的影响最大，混凝土强度等级的影响最小。根据实验测得试块加载端与自由端的荷载和滑移之间的 关系曲线，通过计算分析，提出相应的局部粘结−滑移本构模型。 关键词：碳纤维条；内嵌式；粘结；拉拔实验 中图分类号：TU746.3 文献标识码：A 文章编号：1672-7207(2007)02−0357−05 Bond behavior of NSM CFRP plate-concrete interface in pull-out experiment ZHOU Chao-yang, HU Zhi-hai, HE Xue-jun, LI Bei (School of Civil and Architectural Engineering, Central South University, Changsha 410075, China) Abstract ：A new type of pull-out test set-up with C-shaped specimen was devised to study the bond behavior on the interface of CFRP (carbon fiber-reinforced polymer) plate strips and concrete. Such tests can reduce the influence of eccentricity. The effect of bond length, concrete strength and dimension of the groove on bonding interface was investigated. The result shows that the pull-out load increases when these parameters increase. The major effect comes from bond length and the minor from concrete strength. The local bond-slip relationships are also discussed based on the load-slip relation measured from the test and a constitutive model is suggested by the analysis. Key words: carbon fiber-reinforced polymer strip; near-surface mounted; bond; pull-out experiment [4−5] [6] 内嵌 FRP(Fiber reinforced plastics)加固法与传统