基于C-V模型的工业CT三维图像曲面面积与内腔体积测量算法研究-计算数学专业论文.docxVIP

重庆大学硕士学位论文英文摘要 重庆大学硕士学位论文 英文摘要 PAGE PAGE IV The C-V geometric active contour model is based on the theory of partial differential equations. The segmentation result which is globally optimal, continuous edge can be gained by using C-V model, and C-V model which has strongly noise immunity is the effective image segmentation method currently. Therefore, we use C-V model to segment the industrial computed tomography images, extract the measured target area, then track the contour points of the target area, and store by chain code; secondly, the center points of outline edge on the surface are acquired, calculate the distance data between points on the surface and the center point. Then use Gaussian filter to smooth contour, so that the edge and burr’s effect on measurement can be eliminated; thirdly, establish triangles between contour points of each layer, calculate the surface area by computing the triangles area. Use Green formula to compute the area of each piece, use Platform formula to compute the lumen volume area. The experimental results shows: the segmentation method on this paper can segment objective regions effectively, compared to the traditional measurement methods the method could more accurately acquire curved surface and lumen volume areas. Key words ： reverse engineering ； surface measurement ； industrial CT ； image segmentation；contour filter 重庆大学硕士学位论文目录 重庆大学硕士学位论文 目 录 目 录 中文摘要I 英文摘要 II 1 绪 论 1 1.1 课题研究的背景和意义 1 1.1.1 图像测量技术简介 1 1.1.2 曲面测量技术简介 2 1.1.3 工业 CT 技术简介 4 1.2 课题研究现状 6 1.3 论文主要内容安排 9 2 C-V 模型理论基础 10 2.1 曲线演化理论 10 2.2 水平集方法 12 2.2.1 水平集方法的基础理论 13 2.2.2 水平集方法的数值实现 14 TOC \o 1-2 \h \z \u HYPERLINK \l _TOC_250007 2.3 C-V 模型原理 15 HYPERLINK \l _TOC_250006 2.3.1 C-V 模型 16 HYPERLINK \l _TOC_250005 2.3.2 C-V 模型的水平集表示 16 HYPERLINK \l _TOC_250004 2.3.3 C-V 模型方法的数值实现 18 HYPERLINK \l _TOC_250003 2.4 C-V 模型的改进模型 19 HYPERLINK \l _TOC_250002 2.4.1 扩展的 C-V 模型 20 HYPERLINK \l _TOC_250001 2.4.2 多目标提取的 C-V 模型 21 HYPERLINK \l _TOC_250