20122013光纤通信复习题增加适合缩印版By Eamon in Nov 2012.docVIP

(1).Which of the following dispersion dose not exist in single-mode optical fiber? （ D ） A .material dispersion B.waveguide dispersion C.polarization-mode dispersion D.intermodal dispersion (2).The unit of the fiber attenuation coefficient is (C) A. dB B. dBm C. dB/km D. dBm/km (3).the bands of Optical fiber communication is (B) A.0.01um-0.39um B. 0.8um-2.0um  C.0.39um-0.79um D. (4).If the optical input power of a Optical amplifier is 10mW，and the optical output power is 100mW as well ,then its output gain level is (A) A.10dB B.20dB C.30dB D.40dB (5)In order to make sure of the system BER conditions , if the minimum optical input power of the receiver is 1 uW, the sensitivity of the receiver must be (A) A.－30dBm B.－40dBm C.－20dBm D.－43dBm (6)The principal light sources used for fiber optical communications applications are ：（D） A.OA、LD B.PIN、APD C.PD、LED D.LD、LED (7)laser action is the result of three key process，which one of the following is not be included？（D） A.photon absorption B.spontaneous emission C.stimulated emission D.HYPERLINK javascript:showjdsw(showjd_0,j_0)compound radiation (8) A single mode fiber usually has a core diameter of A. A. 10m B. 62.5nm C. 125nm D. 50mm (9)To make sure that the APD photo-detector works properly, a sufficiently D is applied across the p-n junction. A. high forward-bias voltage B. low forward-bias voltage C. low reverse-bias voltage D. high reverse-bias voltage (10) When DFA fiber amplifier uses as light Repeaters, its main effect is B. A. amplifying and regenerating the signal B. regenerating the signal C. amplifying the signal D. reducing the signal noise (11) In graded-index optical fiber,