抑制电磁干扰的电磁带隙结构分析.pdfVIP

Abstract Abstract EBG (Electromagnetic Band Gap) structure is a periodic structure with the characteristics of band-stop, slow-wave, and high-impedance. It can prohibit the propagation of the electromagnetic wave in a certain bandwidth range. It is widely used to suppress the surface wave and signal noise in certain frequency band in the microwave engineering, design of antennas, electromagnetic compatibility, signal integrity and power distribution networks (PDN), so it attracts widespread attention and receives in-depth study. There are two kinds of EBG structures, the mushroom EBG structures and the uniplanar EBG structures. Based on the preliminary results of our project team, the thesis mainly focuses on the simultaneous switch noise (SSN) suppression and the impact on signal integrity performance of two novel uniplanar EBG structures. Ansoft HFSS software which is based on the finite element method is used to simulate and optimize the SSN suppression of the two novel EBG structures, and test boards have been fabricated and tested, the measured results are in good agreement with the simulated results, which shows a good suppression of SSN of the two EBG structures. Ansoft Designer software is used to analyze the impact of the two EBG structures on signal integrity in detail. The results show that good signal integrity performance can be obtained by using differential transmission lines on PCB. Key words: Electromagnetic Interference Electromagnetic Band Gap (EBG) Printed circuit boards(PCB) Simultaneous Switching Noise (SSN) 目录 目录 第一章 绪论 1 1.1 研究背景及意义 1 1.2 发展现状 2 1.3 研究内容和章节安排 7 第二章 电磁带隙结构的分类、应用及分析方法 9 2.1