表面织构化聚酰亚胺薄膜超声电机摩擦材料性能探究.pdfVIP

第46卷第9期 应　 用　 化　 工 Vol.46 No.9 2017年9月 Applied Chemical Industry Sep.2017 表面织构化聚酰亚胺薄膜超声 电机摩擦材料性能研究 王丰,丁庆军,赵盖,王星 (南京航空航天大学 材料科学与技术学院,江苏 南京　 210016) 摘　 要:采用原位聚合法制备出厚度约为100 μm 的聚酰亚胺薄膜,激光熔融法在薄膜表面刻蚀出不同形状的表面 织构。 研究表面织构对聚酰亚胺薄膜力学性能及摩擦学性能的影响。 测试了不同形式的织构对超声电机机械输 出性能的影响。 结果表明,织构的存在,使得薄膜的拉伸强度有所降低;摩擦系数降低,且摩擦系数更加稳定,磨损 率有所降低,使得超声电机机械输出性能更加稳定。 关键词:聚酰亚胺薄膜;摩擦磨损;表面织构化;超声电机 中图分类号:TQ317.5　 　 文献标识码:B　 　 文章编号:1671-3206(2017)09-1859-04 Study on properties of surface texturing polyimide films friction materials of ultrasonic motor WANGFeng,DING Qing-jun,ZHAO Gai,WANGXing (College of Materials Science and Technology,Nanjing University of Aeronautics and Astronautics,Nanjing210016,China) Abstract:Polyimide filmswith thickness of about 100 μm were fabricated by in-situ polymerization.The surface texture of polyimide film was etched by laser melting method.The effects of surface texturing on the mechanical properties and tribological properties of polyimide films were investigated.The effects of different types of textures on the mechanical output performance of the ultrasonic motor were tested.The results show thatthetensilestrengthofthefilmdecreaseswiththepresenceoftexturing,thefrictioncoef- ficient of the surface-textured filmswere lower and the friction coefficient were more stable and the wear rate werelowerthanthat of the smoothpolyimidefilm.Thepresenceof texturemakestheultrasonicmotor mechanical output performance more stable. Key words:polyimide film;friction and wear;surface texture;ultrasonic motor 　 　 超声电机是一种新型微型电机,其工作原理是 擦材料。 Rehbein等制备出聚酰亚胺-碳纤维材料, 利用压电材料的逆压电效应,激发弹性体(定子)在 在高频振动条件下测得材料具有较高