原创力文档- 1、原创力文档（book118）网站文档一经付费（服务费），不意味着购买了该文档的版权，仅供个人/单位学习、研究之用，不得用于商业用途，未经授权，严禁复制、发行、汇编、翻译或者网络传播等，侵权必究。。
- 2、本站所有内容均由合作方或网友上传，本站不对文档的完整性、权威性及其观点立场正确性做任何保证或承诺！文档内容仅供研究参考，付费前请自行鉴别。如您付费，意味着您自己接受本站规则且自行承担风险，本站不退款、不进行额外附加服务；查看《如何避免下载的几个坑》。如果您已付费下载过本站文档，您可以点击 这里二次下载。
- 3、如文档侵犯商业秘密、侵犯著作权、侵犯人身权等，请点击“版权申诉”（推荐），也可以打举报电话：400-050-0827(电话支持时间：9:00-18:30)。
查看更多
41 2 () Vol.41 No.2
2010 4 Journal of Central South University (Science and Technology) Apr. 2010
( 410083)
X
TiY O 1 300~1 450 1 300
54.8
700 X
Cr
TG113.25+ 1 A 1672−7207(2010)02−0455−05
Microstructure and mechanical properties of
hot-forged powder metallurgy Fe-based alloys
LIU Dong-hua, LIU Yong, ZHAO Da-peng, LIU Zu-ming
(State Key Laboratory of Powder Metallurgy, Central South University, Changsha 410083, China)
Abstract: The evolution regularity of microstructures and mechanical properties of a forged Fe-based alloy were
investigated by optical microstructure, energy spectrum analysis, X-ray diffractrometry and Rockwell hardness testing.
The results show that few nucleus of crystal is formed on the forged Fe-based alloy, the grains occur recrystallization and
the second phase is composed of Ti, Y and O precipitated at grain boundary. The forged samples occur recrystallization at
1 300−1 450 through high temperature treatment. The HRC hardness is 54.8 at 1 300 , because there occurs full
recrystallization, and the grain size becomes fine, the secondary phase is dispersively distributed within grains. The
hardness decreases with the increase of temperature of heat treatment, because the grain size of recrystallization is
unchanged but softening occurs. After annealing at 700 , crystal size of the forged Fe-based alloy changes unobviously,
and the hardness decreases because of the dextral deviation of X-ray diffraction peak and the decrease of
文档评论（0）