弹簧式安全阀.docVIP

弹簧式安全阀 安装、使用说明书 INSTALLATION AND USAGE MANUAL FOR THE SPRING SAFETY VALVE 杭州华惠阀门有限公司 杭州阀门厂 HANGZHOU WORLDWISE VALVE CO.，LTD HANGZHOU VALVE FACTORY STAND：AUG ，2008 弹簧式中、低压和次高压系列安全阀是我公司自行研制开发的主导产品之一，使用至今越来越受广大顾客的欢迎。为了使各行业的顾客能更好地了解和使用我公司的系列安全阀，特制定本说明书，以便于安全阀的安装和使用。 Series Spring Safety Valve(spring style) in low、 middle 、sub-high pressure is one of our leading products which is widely used in China. For better understanding and usage of the series safety valve, this manual explains the terms of installation and operation. 安全阀的结构简介 Safety Valve Structural Introduction 1．以下的结构图示中: The following figures denote: 图1为41型，封闭微启式； Figure 1 shows 41 type, sealed micro-lift type; 图2为42型，封闭全启式； Figure 2 shows 42 type, sealed full-lift type; 图3为44型，封闭全启式带扳手； Figure 3 shows 44 type, sealed full-lift type with spanner; 图4为47型，非封闭微启式带扳手； Figure 4 shows 47 type, non-sealed micro-lift type with spanner; 图5为48型，非封闭全启式带扳手； Figure 5 shows 48 type, non-sealed full-lift type with spanner; 图6为48s型，非封闭全启式隔热架带扳手 Figure 6 shows 48s type, thermal-insulated non-sealed full-lift type with spanner; 图1 图2 图3 Figure 1 Figure 2 Figure 3 图4 图5 图6 Figure 4 Figure 5 Figure 6 安装、使用和调整 Installation、Usage and Adjustment 1．安装 1、Installation 安全阀安装前对管道必须进行彻底的清管吹扫处理。 Be sure blow-clean the pipe before installation. 安全阀必须竖直安装，入口管的内径不小于安全阀的入口通径，并要有必要的支撑（见图7） The safety valve should be installed vertically, the inner-diameter of the inlet pipe should be more than the valve’s nominal diameter, the valve should be supported.(Refer to Figure 7) 图7 Figure 7 出口排放管的内径应不小于安全阀的出口通径，排放的阻力应尽可能小，一般阻力压降小于整定压力的10％。 The inner-diameter of the discharging pipe should be more than the outlet nominal diameter of the safety valve. Discharge resistance should be as less as possible, resistance dif