基于AT89C51单片机的智能电流检测系统设计-毕业设计.doc

毕业设计论文 PAGE xviii 陕西理工学院毕业设计论文 第 PAGE xviii 页 共 NUMPAGES 35页 基于单片机的智能电流检测系统的设计 [摘要]：电流检测系统是一种比较成熟的技术，但是基于单片机的电流检测系统是近来新兴的一种技术，主要优点是可以一次将多个电流信号测量并显示出来。 本文阐述了基于单片机的智能电流系统设计的组成及设计方法。它的设计是为了检测比如直流、交流以及脉冲电流信号的有效值或者平均值。它是在AT89C51单片机的基础上搭建硬件，配合c语言编程，通过keil软件和proteus软件将仿真结果显示出来。最后与准确电流的对比，精确程度能达到98%。 本文只是进行了理论仿真，未进行实物搭建，对后续工作还有待于进一步研究。 [关键字]：电流检测系统；单片机硬件；编程；仿真 Design of Intelligent Current Detection System Based on MCU Abstract: The current detection system is a relatively mature technology, but the microcontroller-based current detection system is a recently emerging technology. Its main advantage is that more than current signals can be measured and displayed. This article describes the composition and design methodology of design of intelligent current detection system based on MCU. It is in order to detect such as DC, AC and pulse current signal RMS or average. It is to build the hardware on the basis of AT89C51 microcontroller with C language programming, Keil software and Proteus software simulation results displayed. Finally, compared with accurate and current, the precision of the detection system can reach 98%. This article run a theoretical simulation, without building physical structures. The follow-up also needs further study. Key word: Current detection system; single-chip; hardware; programming; simulation 毕业设计论文 PAGE \* MERGEFORMAT I 目 录TOC \o 1-3 \h \u HYPERLINK \l _Toc18326 绪论 PAGEREF _Toc18326 1 HYPERLINK \l _Toc3217 1 电流测量系统的整体设计 PAGEREF _Toc3217 2 HYPERLINK \l _Toc15905 2 电流检测系统的硬件设计 PAGEREF _Toc15905 3 HYPERLINK \l _Toc22298 2.1 电流供给电路设计 PAGEREF _Toc22298 3 HYPERLINK \l _Toc13729 2.2 数据采集及转换电路设计 PAGEREF _Toc13729 3 HYPERLINK \l _Toc18020 2.2.1．ADC0808简介 PAGEREF _Toc18020 3 HYPERLINK \l _Toc21762 2.2.2单片机与ADC0808接口设计 PAGEREF _Toc21762 6 HYPERLINK \l _Toc21670 2.3 单片机显示电路设计 PAGEREF _Toc21670 7 HYPERLINK \l _Toc18606 2.3.1 液晶显示器LM016L简介 PAGEREF _Toc18606 7 HYPERLINK \l _Toc29545 2.3.2 LM016L与单片机接口设计 PAGEREF _Toc29545 11