矩阵整流器的相关问题的研究-电气工程专业毕业论文.docxVIP

ABSTRACT Typically, traditional power electronic devices connect power grid through rectifier, however, with industrial development and the enhancement of social standards, traditional rectifier faces multiple challenges in many aspects as high level of input current harmonic, low level of input power factor and voltage transfer ratio. Matrix rectifier derives from three-phase matrix converter with advantages like adjustable input power factor, better sinusoidal waveform and bidirectional flow of energy, all these advantages have exerted a great influence in DC field and thus attracting extensive attention worldwide. The Mathematical and physical basis of the matrix converter is introduced in the article first, then the switching function algorithm and double space vector algorithm, by which the relevant algorithms of the matrix converter are inferred. This article has analyzed space vector algorithm and conducted current vector overmodulation for the system, and then concluded the ties between current overmodulation and output voltage: to enhance modulation index of the matrix converter above overmodulation field can produce higher output voltage than those use traditional modulation methods. Besides, the two-step commutation and four-step commutation methods for the switching tubes in the matrix converter are also analyzed. According to switching function algorithm, the harmonic characteristic of input current is concluded: the amplitude of high frequency harmonic is inversely proportional to induction. Then the basic ideas of parameter design of the input filter are approached on the basis of its character and that of the system. After that, the simulation model of the system is built on Simulink platform, the simulation results conform with expectation and therefore proving the reliability of the above-mentioned algorithms. Finally, both the hardware circuit and the flow chart of software was provided, which laid a foundation for the next experimental research.