三相变压器并列运行仿真研究-电气工程专业毕业论文.docxVIP

AbstractAbstract Abstract Abstract A common running way of power transformer is running in parallel，in power plants and substations，in order to improve the reliability of power supply,we usually use two or more power transformers to operate in parallel，thus when transformer quits running because of fault，the other transformer still Can continue to supply electricity．In substation，two more transformers operating in parallel can also meet the needs of economical operation，part of the transformers will quit running at low load in order to reduce energy loss．In the construction of substation，sometimes because of the voltage quality can’t meet the requirements，the voltage ratio of the two purchased transformers will be different，or short circuit voltage is different as a result of the type of transformer is not the salTle，there may be some problems if they are running in parallel．Transformer is a very important equipment and it’s very expensive，parallel operation experiment has a great deal of risk and even causes the damage of transformer if it is carried out directly．Using Matlab／Simulink software to carry out the simulation of the three—phase transformer’S parallel operation，you can easily change the transformer parameters，set the size of load and alter the operation mode；it is an effective method to research the parallel operation of three-phase transformer．The simulation of three-phase transformer’S parallel operation provide the correct basis for transformer’S parallel operation in actual substation，Call also be used to verify the transformer’S parallel operation theory,since the theoretical analysis ignore the influence of transformer’S internal resistance，using Matlab／Simulink software to do the simulation iS closer to the actual situation． This paper introduces the function and the programming system of Matlab／Simulink，the magnetic circuit system of three-phase transformer as well as the winding connection and the T equivalent circuit；derives the model p