三维模拟表面弹塑性接触问题研究-机械制造及其自动化专业论文.docxVIP

万方数据 万方数据 Abst Abstract Title: THE RESEARCH ON ELASTIC-PLASTIC CONTACT PROBLEM OF 3D SIMULATED SURFACE Major: Machinery Manufacturing and Automatization Graduate：Pan FENG Signature: Supervisor：Associate Prof. Pengyang LI Signature: Abstract The contact problem between the machine components has an important effect on the performance of the mechanical system, but the contact performance between the machine components mostly depended on the surface topography. In this work, the elastic-plastic contact is calculated after simulating the real joint surface. First of all, the surface obtained by mechanical processing was measured, and the surface data is statistically analyzed. Based on the statistical analysis of the data, the important surface topography parameters : such as the surface RMS, the skewness, and the kurtosis, are used to simulate the real surface. Secondly, the real surface is simulated by using the surface topography parameters. The turning and milling surfaces are simulated which the roughness is 0.8, 1.6 and 3.2, which provided mathematical model of the real surface for the contact calculation. The errors among the surface RMS, the skewness, the kurtosis between the simulated surface and the measured surface are analyzed, the errors are all within ±5%. Then the elastic-plastic contact model is established, and the surface mathematical model which simulated the machining surface simulation is calculated too.The distribution of residual stress, the distribution of surface strain and the distribution of the Von Mises are calculated in dirrerent kinds of processing under the same surface press. In this thesis the relationship between the normal strain and normal press per unit area under different process or different roughness is also analyzed. Then the relationship between the normal stiffness and normal press per unit area under different process or different roughness are obtained. Finally, a contact experiment to validate the effectiveness of the meth