冷轧乳化液废水深度处理的中试研究-市政工程专业论文.docxVIP

华中科技大学硕士学位论文 华 中 科 技 大 学 硕 士 学 位 论 文 II II Abstract Because of the poor biodegradability and high pollutant concentration of emulsion wastewater from cold rolling mill, emulsion wastewater is one of the refractory wastewater produced in iron and steel plants. As the normal treatment methods have unsatisfied effect on treating emulsion wastewater, this paper proposes a combined process of hydrolysis-acidification/ activated sludge process/constructed wetland to treat emulsion wastewater. Lab research and pilot test have been done to study this advanced treatment, and the conclusions are as following: From the lab research, the feasibility and treatment effect of the combined process of hydrolysis-acidification/activated sludge process on treating emulsion wastewater was investigated .The results show the combined process has nice feasibility and treatment effect on treating emulsion wastewater. From the pilot test of the advanced treatment by hydrolysis-acidification/activated sludge process/constructed wetland, the appropriate operating condition of this advanced treatment are concluded: influent pH is7~9, temperature is 18～30℃, volume loading of hydrolysis-acidification reactor, activated sludge reactor is 1.07～2.04kgCOD/(m3·d), 0.84～1.97kgCOD/(m3·d), the DO concentration of activated sludge process is near 3 mg/L, and the COD concentration of influent for constructed wetland is below 400 mg/L.. Under this operating condition, the combined process has good treatment effect, the effluent COD concentration is reduced from 953～2251mg/L to 31～145mg/L, as the removal rates of COD is 91.3%～98.2%, and the effluent SS concentration is reduced from 651～1128 mg/L to 29～54mg/L, as the removal rates of SS is 92.3%～96.1%. Key words：Emulsion wastewater from cold rolling mill; Hydrolysis-acidification; Aerobic activated sludge process; Constructed wetland; Tertiary treatment 独创性声明 本人声明所呈交的学位论文是我个人在导师指导下进行的研究工作及取得的 研究成果。尽我所知，除文中已经标明引用的内容外，本论文不包含任何其他个 人或集体已经发表或撰写过的研究成果。对本文的研究做出贡献的个