选区激光熔融技术制备多孔支架及其单元结构的拓扑优化.pdf

第43卷 第4期 北 京 工 业 大 学 学 报 Vol.43 No.4 2017年 4月 JOURNAL OF BEIJING UNIVERSITY OFTECHNOLOGY Apr. 2017 选区激光熔融技术制备多孔支架及其单元 结构的拓扑优化 1,2 1,2 1,2 1,2 陈继民 ,王摇 颖 ,曹玄扬 ,李东方 (1.北京市数字化医疗3D打印工程技术研究中心,北京摇 100124;2.北京工业大学激光工程研究院,北京摇 100124) 摘摇 要:针对传统制造多孔结构具有的盲目性和不确定性以及如何将多孔结构有效的设计理念应用于实际制造的 问题,提出了一种设计及制造具有多孔支架结构的方法. 该方法通过设计单元结构,使其组成的多孔结构能在降低 弹性模量的基础上保证结构的力学性能. 首先,应用Optistruct软件对单元结构进行拓扑优化,提取优化的单元结 构;然后,在Magics里将单元模型修复、阵列得到多孔支架,用选区激光熔融技术制造多孔支架;最后,对多孔结构 的力学性能进行了测试. 实验结果表明:多孔支架的弹性模量与抗压强度值均在骨骼的要求范围内. 关键词:拓扑优化;多孔结构;选区激光熔融;弹性模量 中图分类号:TG665 文献标志码:A 文章编号:0254-0037(2017)04-0489-07 doi:10.11936/ bjutxb2016120028 Topology Optimization of Microstructure and Selective Laser Melting Manufacture for Porous Scaffolds 1,2 1,2 1,2 1,2 CHENJimin ,WANG Ying ,CAO Xuanyang ,LI Dongfang (1.Beijing Engineering Research Center of 3D Printing for Digital Medical Health,Beijing 100124,China; 2.Institute of Laser Engineering,Beijing University of Technology,Beijing 100124,China) Abstract:Tosolvetheproblemthattraditionalmanufacturinghasblindnessanduncertainty oftheporous structure,and a design concept of effective porous material was applied to the actual manufacturing. A design and manufacture porous scaffolds structure method was proposed. The porous structure mechanic property was guaranteed on the basis of lower elastic modulus through design unit cell. Unit structure topology optimization and extraction were made by the software of Optistruct. Scaffolds were obtained by repairing and arraying the software of Magnics. The poro