机械设计制造及自动化专业毕业论文--榨汁机内支架塑料模具设计.docVIP

机械设计制造及自动化专业毕业论文--榨汁机内支架塑料模具设计 专 业 机械设计制造及自动化 班级学号 机自 – 0542 学生姓名 纪华 指导教师 蔡玉俊 副教授 二〇〇七 年 六 月 天津工程师范学院本科生毕业设计 　Plastic mould design of Juice-extractor part 专业班级机自0542 学生姓名纪 华 指导教师蔡 玉 俊 副教授 系 别机械工程系 2007年6月 摘 要 模具行业是国民经济的一项重要行业近年来模具一直朝着高质量高效率低成本短周期的方向发展传统的模具设计中模具设计者们是利用二维CAD软件来进行初步设计的然而现在三维模具设计已经被广泛使用它使设计过程接近标准化使初步设计得以迅速实现在本设计中将对榨汁机内支架的模具通过ProENGINEER软件进行三维设计并对设计过程进行讲解 在本设计中首先对塑件结构材料特性用途以及参数进行分析确定模具采用一模两腔并使用点浇口填充型腔的总体布局形式在模具设计过程中对侧向抽芯机构分型面的设计浇注系统排气系统冷却系统脱模机构进行了详细的介绍最后通过对注塑机参数校核和生产验证证明模具结构设计合理性 通过本次模具设计可以看出三维模具设计可以缩短设计周期提高设计质量大大的增加工作效率 关键字榨汁机内支架注塑模具一模两腔侧向抽芯机构 ABSTRACT The die and mould industry is an important industry of the national economy In recent years mould is developing towards high quality high efficient low cost and short- period In traditional mould design mould designers was using 2D CAD Software Tools to proceed the preliminary design However 3D mould design already has been used extensively nowadays which makes mould design approach to standardization and makes preliminary design quickly realize In this article it presents 3D mould design for juice-extractor part by ProE and explains its design process in detail In this design at first it have analyzed the plastic part structure material properties use and parameters ascertained the mould layout form of One to Two cavities and adopted the general distribution form of pin-point gate filling with cavity In this mould design process it has introduced in detail for side Core-Pulling mechanism the design of parting surface gating system and venting system cooling system ejection mechanism Finally through checking and production proofing for molding machine parameters the mould structure is proved to be reasonability Through this mould design it may find out that 3D mould design can shorten design cycle raise design quality and largely increase the working efficiency Key words Juice-extractor part Plastic injection mould One mould tw