广安站继电保护配置及整定计算电气工程及自动化专业毕业设计毕业.docxVIP

【摘要】 为满足电网对继电保护提出的可靠性、选择性、灵敏性、速动性的要求，充分 发挥继电保护装置的效能，必须合理的选择保护及其的定值，以保持各保护之间的 相互配合关系。做好变电站继电保护定值的整定计算工作是保证电力系统安全运行 的必要条件。 木文详细地讲述了如何根据llOkV广安变电站电气主接线及基木参数，参数标 幺化，进行短路电流计算，进而根据国家继电保护规程，对变压器，liokv线路， 35kV线路配置相应保护。并通过对所配置的继电保护进行整定计算和校验，论证继 电保护配置的正确性。并加装自动重合闸装置，提高供电可靠性。 关键词：短路电流计算；继电保护配置；三段式电流保护 [Abstract] In order to meet the needs of power network on relay protection is presented and the reliability, selectivity, sensitivity, liquid requirement, give full play to the performance of relay protection devices, must be a reasonable choice of protection setting value, in order to maintain the relations between each othe匚 Do a good job of relay protection setting calculation is to ensure the safe operation of the power system and necessary condition. This paper describes how to analyze the selected 11 OkV grid relay protection 一 three distanee protection, four section of zero sequence protection, as well as the transformer differential protection and the backup protection,35kV current protection, and the setting calculation and verification of whether or not to meet the regulations and requirements. And through a given 1 lOkV wiring diagram and parameters, short-circuit current calculation, based on the configuration of relay protection setting calculation and checking of relay protection configuration, proved correct. Key words： Short-circuit Current Calculation; Relay Protection Configuration ; Three phase current protection; TOC \o 1-5 \h \z \o Current Document 1引言 1 \o Current Document 1.1本文研究背景意义 1 \o Current Document 本文主耍内容 1 \o Current Document liokvr安站原始资料 2 \o Current Document 1变电站接线图及运行方式 2 \o Current Document 2.2主变压器型号及参数 2 3 35kV线路情况 3 \o Current Document 3短路电流计算 4 \o Current Document 3.1短路计算的目的 4 \o Current Document 2基准值的选择 4 \o Current Document 3.3短路电流计算的步骤 4 \o Current Document 3.4各元件参数标么值的计算 5 \o Current Document 3.4短路电流的计算 6 \o Current Document 4继电保护及安全自动装置的配置原则 9 \o Current Document 1 总则 9 \o Current Document llOkV线路保护配置原则 9