中孔钢管安装施工方案(最新修改).doc

吉布3水电工程 GibeⅢhydroelectricproject 中孔钢管安装施工方案 Methodstatementofmiddleoutletpenstock 审批Approvedby: 校核Checkedby: 编写Compiledby: 中国水利水电第八工程局机电制造安装分局埃塞吉布3项目部 SinohydroBureau8ElectricalandMechanicalFabricationErectionDivisionEthiopiaGibeIIIHydroelectricProjectDepartment 二零一三年一月二十四日 2013.01.24 目录 Contents 1. 概述 General 3 2. 施工准备 Construction Preparation 5 2．1安装前检查 Inspecting before erection 5 2．2 控制样点放置Setting out reference points 5 2．3技术要求Technical requirements 5 3. 中孔钢管安装Erection for Middle Outlet Steel Lining 6 3．1定位节、凑合节的选取Selection of locating section and fitting allowance section 6 3．2钢管的吊装及就位 lifting and positioning of steel lining 7 3．3钢管的转运、临时堆放 transportation and temporary stacking of steel lining 8 3．4钢管的安装场地基本要求 Basic requirements for steel lining erection area 9 3．5用于钢管安装调整加固的埋板、锚筋 Embedded parts, anchor bar used for steel lining erection, adjustment and reinforcement 10 3．6钢管的安装 Erection for steel lining 11 3．6．1钢管安装的流程图 Steel lining erection procedure flow chart 11 3．6．2钢管的安装主要工序General process of steel lining erection 12 3．7钢管的焊接 Welding of steel lining 14 3．8钢管的最终验收 final acceptance of steel lining 14 3．9钢管验收后的移交 Handing over after acceptance 15 4. 下游闸门埋件及钢衬安装 Embedded parts and steel liner installation for downstream gate 15 5. 上游闸门埋件安装 Embedded parts installation for upstream gate 19 6. 工期及资源配置 construction duration and resource allocation 20 6．1劳动力资源 manpower resource 20 6．2主要施工设备投入 Allocation of main construction equipment 21 6．3 钢管安装工期 Erection duration of steel lining 23 7. 安全注意事项 Precautions 24 概述General 埃塞俄比亚吉布3水电工程大坝共设两套泄洪钢管，分为右侧泄洪钢管和左侧泄洪钢管，左、右孔结构及布置形式相同。 TwoflooddischargesteelliningsaredesignedforthedamofEthiopiaGibeIIIHydroelectricProject,whicharedividedintorightsteelliningandleftsteellining.Thebothsidesofoutletareinthesamestructureandlayout. 中孔钢管长度约116.5m，包括为：进口过渡段，渐变段（φ7m~φ6m，弯管段（φ6m），直管段（φ6m），收缩段（φ6m~5.4m）,直管段（φ5.4m），收缩段（φ5.4m~4.6m）,出口渐变段。钢管结构形式如下： Middleoutletsteelliningisabout116.5mlong,consistingofinlettransitionpart,transitionpart(φ7m~φ6m