EDFA spec英文文献资料.pptVIP

EDFA Spec. Introduction 2010/12/22 Optical Specifications for Variable Gain EDFA#1 (EDFAWV2222OPL01 ) Transient This transient model represents a fiber cut or restoration event, further referred to as an event, when a number of channels are dropped or added over a short period of time. Transient Control 当通信中发生上波/下波业务或其他上/下波的突发情况时，由于泵浦电流不能及时改变和粒子上能级的驰豫作用，光信号会产生向下或向上的过冲。 瞬态控制就是FPGA提前对泵浦电流进行控制，以减小或抑制由于Add/Drop所产生的过冲。 Gain mask 88 - 1 - Number of Channel 1564 - 1529 nm Wavelength Bandwidth Operating Range (Line In – Out at Node P) 测试中，我们往往没有88ch或44ch的光源，而使用29ch或更少的通道来模拟。若使总功率一致，则应注意单通道功率的换算。 - - +18.5 dBm Maximum Input power without damage +5.5 - -23 dBm Total Input Power range with Gain Flattened specs * +5.5 - -26 dBm Input power range Input Power (Line In) 入光稳定性测试 上报，get ip PM，ΔP ±0.1 - - dB Gain Stability Band ±0.5 - - dB Steady State Gain Error Band (=Average Gain Accuracy) 1.5 - - dB Gain flatness (include PDG) 22.5 3.0 dB Dynamic Flattened Gain Range Gain 测试：OSA+Yangswitch Average Gain Accuracy：放大器实际平均增益与目标增益之间差值允许的范围 Gain Stability Band：描述信号光在增益相对稳定后的增益变化范围，是一个增益相对时间的量。 Target Actual Gain Average Gain Accuracy 11.3 - - Gain=17.5dB 9.3 - - Gain=20.5dB 7.8 - - Gain=23.5dB 6.8 - - Gain=26.5dB 6.5 - - dB Gain=29.5dB Noise Figure (At Gain Tilt=0dB) NF NF：描述信号经放大器后光信噪比恶化程度的参量 1300 - - us Settling Time at 90us Transient 0.9 - - dB Max Gain Offset 1.55 - - dB Max Swing ±1.0 - - dB Max excursion 0 dBm Mid-Stage Output Power per Channel 7.5 - 0 dB Mid-Stage Access Loss (with auto gain compensation) Max Typ. Min. Unit Specification VOA补偿MSA Loss +2.0 dBm Minimum Working Signal Output Power 23.5 - 23 dBm Saturated Output Power Output Power 出光稳定性测试 上报，get otp PM，ΔP 0.5 - - ps Polarization Mode Dispersion (PMD) 0.3 - - dB Polarization Dependent Gain (PDG) - - 40 dB Optical Return Loss (pump off) Return Loss, Dispersion and Polarization Dependency -30 - - dBm Amplifier Output Pump leakage -40 - -