gb2093a泉州市天益机电26.pdfVIP

Vickers® Servo Valves Power Amplifier for Servo Valves EHA-PAM-291-A-20 Front Panel; Actual Size Wiring terminal clamp screws General Description The EHA-PAM-291-A-20 power amplifier is designed for controlling Vickers SM4 +24V power supply input, green LED servo-valves, or other servo-valves up to +24V 200 mA max. current. Potentiometers Gain, offset and dither (frequency and Gain amplitude) are adjustable by Dither amplitude potentiometers mounted in the front panel. An externally switched, 24V “drive Dither frequency enable” signal is used to switch the Offset power drive on and off. The amplifier is packaged as a EHA-PAM- “snap-on” control module for mounting 291-A-20 into control cabinets using mounting rails to DIN EN 50022 or DIN EN 50035. Wiring terminal clamp screws Features and Benefits LED shows when 24V power supply is present Two test terminals allow dither amplitude and gain setting (output current) to be measured, simplifying start-up and fault finding Output stage is short circuit protected “Drive enable/disable” controlled by external signal Uni-polar voltage input; bi-pol