gb2101a泉州市天益机电31.pdfVIP

Vickers® Amplifier Cards Power Amplifiers for Proportional Valves EEA-PAM-56*-A-14 Design EEA-PAM-561-A-14 for use with valve Analog command input signals can be Features types: non-inverting current, or non-inverting, KDG5V-5, 3* and KDG5V-7, 1* series inverting or differential voltages. The Basic valve amplifier EEA-PAM-568-A-14 for use with valve amplifier requires a power supply of 24V Voltage and current command signals types: DC and is enabled by a 24V logic signal. 1 ramp for acceleration and KDG5V-8, 1* series deceleration The ramp is normally enabled but can 24V DC power supply General Description be selectively disabled by suitable wiring Pulse-width-modulated coil drives to an external switch. This basic amplifier is designed for 14-design Features driving Vickers type KFDG5V-5/7/8, The amplifier front panel contains LEDs Wider supply voltage range plus 2-stage proportional valves in showing the status of power, control increased tolerance to ripple applications requiring only one supply and outputs. Potentiometers for Low supply voltage protection (adjustable) ramp setting for both adjusting ramp, deadband Additional monitor points on edge acceleration and deceleration. compensation and gain are also