gb2315泉州市天益机电38.pdfVIP

Vickers® Amplifier Cards EBA-TEQ-706-A-10 Eurocard Test Adaptor General Description Input Int./Ext. With “EXT” selected the amplifier (and This low cost test equipment is designed hence the valve and actuator) are for easy connection to a standard controlled from the user’s control Vickers Eurocard-format, EEA-PAM-5** system. With “INT” selected the control series amplifier, to facilitate voltage and signal is derived from the potentiometer current measurements during set-up or on the test equipment. fault diagnosis. The Vickers EEA-PAM-5** series amplifiers have a common edge connector pin Panel Arrangement arrangement which allows the test equipment to be used for all amplifiers in the series. The amplifier to be tested is first removed from the control panel or cardholder and the EBA-TEQ-706-A-10 installed in its place. Testing can be started when the amplifier is plugged in +10V to the free end of the test equipment, where it is held by latches. –10V The -TEQ- panel contains a control GND. Ø2 mm (0.0787 dia) Command signal potentiometer, switches to select varying attenuation sockets for voltage 24V measurements circuitry options, and a number of potentiometer sockets. Four pairs of these sockets are