刻槽钻杆应用于突出煤层钻进的合理参数研究-煤炭学报.pdf

摇 第36卷第2期 煤摇 摇 炭摇 摇 学摇 摇 报 Vol.36摇 No.2摇 摇 2011年 2月 JOURNAL OF CHINA COAL SOCIETY Feb.摇 2011摇 摇 摇 文章编号:0253-9993(2011)02-0304-04 刻槽钻杆应用于突出煤层钻进的合理参数研究 王永龙,翟新献,孙玉宁 (河南理工大学 能源科学与工程学院,河南 焦作摇 454000) 摘摇 要:为充分发挥刻槽钻杆应用于突出煤层钻进的优势,分析了刻槽钻杆螺旋槽宽度、深度、螺距 的变化对排渣效果的影响情况。 建立准50 刻槽钻杆煤层钻孔三维模型,对不同参数的刻槽钻杆在 钻孔内的排渣情况进行数值模拟。 研究结果表明:螺旋槽宽度为12 mm,深度为1郾1 mm,螺距为 76 mm,排渣效果最优;通过突出煤层钻进工业性试验,钻进深度平均提高36郾2%,钻进效率提高 41郾5%,且刻槽钻杆表面温差较小。 关键词:刻槽钻杆;突出煤层;螺旋槽;钻进深度;钻进效率 中图分类号:TD823郾82摇 摇 摇 文献标志码:A Reasonable parameters study on grooved drill pipe used in drilling outburst coal seam WANG Yong鄄long,ZHAI Xin鄄xian,SUN Yu鄄ning (School of Energy Science and Engineering,Henan Polytechnic University,Jiaozuo摇 454000,China) Abstract:In order to givefull play to the advantage of the grooved drill pipe used in outburst coal seam,analyzed the effect of changes of spiral鄄channel width,depth and pitch of grooved drill pipe on the slag removal.Established coal seam drilling three鄄dimensional model for 准50 grooved drill pipe,carried on a numerical simulation for the grooved drill pipe slag removal situation in drilling.The results of study show that when the spiral鄄channel width L=12 mm, depth H=1.1mm,pitch S=76 mm,the slag removal result is optimal.Through the industrial experiment in outburst coal seam,the depth of drilling improvesby36郾2% on average,the efficiency of drilling improvesby41郾5%,andthe difference in temperature is smaller on the surface of grooved drill pipe. Key words:grooved drill pipe;outburst coal seam;spiral鄄channel;depth of drilling;efficiency of drilling 摇 摇 当前煤层施工钻孔最常用的钻杆为光面钻杆和 厚的光面钻杆表面刻制螺旋槽,采用流体排渣方式进 麻花钻杆,在松软煤层和突出煤层施工钻孔时,钻孔 行钻进,同时发挥螺旋槽的辅助排渣作用,因此,