滚筒反力式制动试验台制动力检测分析-中国测试杂志社.pdf

第41卷第4期 中国测试 Vol.41 No.4 2015年4月 CHINA MEASUREMENT TEST April，2015 doi院10.11857/j.issn.1674-5124.2015.04.003 滚筒反力式制动试验台制动力检测分析 赵英勋 （武汉科技大学汽车与交通工程学院，湖北 武汉 430070） 摘 要院为减少汽车制动试验台检测的误判率，提出滚筒反力式制动试验台的检测对策。通过分析试验台的检测模 型，求得试验台在车轮与前后滚筒接触、车轮脱离前滚筒两种状态下的最大检测能力。分析表明：试验台最大检测能 力过小是导致制动性检测误判的原因。采用高附着性能的试验台滚筒，设计合适的试验台安置角、增大制动检测的水 平约束力、改进制动检测的评价方法，可提高试验台检测能力并减少误判。 关键词院滚筒；制动试验台；制动力；检测；安置角 文献标志码院A 文章编号院1674-5124渊2015冤04-0010-04 Detection and analysis of brake force based on roller opposite-force brake tester ZHAO Yingxun （College of Automobile and Traffic Engineering，Wuhan University of Science and Technology， Wuhan 430070，China） Abstract: In order to reduce the misjudgment rate of the automobile brake on the test bench， this paper proposes a countermeasure for detecting roller opposite-force brake testers. Through analyzing the detection model on the test bench，the maximum detection capacity was obtained under these two conditions of the wheel in contact with the front and back rollers and the wheel broke away from the front roller. The analysis showed that，the maximum detection capacity on the test bench was too small to cause the misjudgment of brake test. The test ability can be improved and the misjudgment on the test bench can be reduced by using the test roller of high adhesion，designing appropriate placement angle，increasing the level force of the brake test and improving the evaluation methodology thereof. Keywords: roller；brake tester；brake force；detection；placement angle 0 引 言