原创力文档* * Density feedback control with SMBI and ECRH SONG Xianming, LUO Cuiwen YAO Lianghua, ZHOU Jun Southwestern Institute of Physics, P.O.Box 432, 610041, Chengdu, China content 1 characteristics of SMBI 2 setup of SMBI in HL-2A 3 experimental results only with SMBI 4 experimental results with both SMBI and ECRH 1 characteristics of smbi SMBI has advantages over Gas Puffing, close to PI performance but cheaper. More control options, temperature, pressure. H-alpha has a quick response to SMBI, so does density. SMBI has weak effect on wall recycling. A comparison of injection behavior among GP, PI and CJI. 1 characteristics of SMBI Comparison of Response for density and H-alpha between GAS PUFFING and SMBI 1 characteristics of SMBI 1 characteristics of SMBI Gas puff:( Piezo-Electric gas leak Valve from Key High Vacuum Products Inc.) room temperature, 0.2MPa,1ms width. SMBI: -165 Celsius, 4.0MPa, 1ms width Setup of SMBI Parker Instrumentation, Parker Hannifin Corporation， general valve division， IOTA ONE pulse driver ）（Parker S-99 Valve） Fig.2. Supersonic molecular beam and cluster. The gas undergoes an isentropic expansion in the nozzle and into vacuum, forming a supersonic beam, if the temperature of stagnation gas is at nitrogen liquid and the backing pressure is high enough then some clusters within the beam. 2 setup of SMBI in HL-2A 3 experimental result only with SMBI SMBI Parameter: room temperature, p=1.0MPa, width variable comment: gas injected per pulse is much more, cause disruption. 3 experimental result only with SMBI SMBI Parameter: room temperature, p=0.6MPa, width=2ms comment: gas injected per pulse is a little more, so disturbance is large. 3 experimental result only with SMBI SMBI Parameter: room temperature, p=0.6MPa, width=2ms comment: target ne too low, no feedback, natural background ne 3 experimental result only with SMBI SMBI Parameter: room temperature, p=0.4MPa, width variable with maximum width 2ms. comment:
文档评论（0）