基于stc89c51单片机的数码管时钟.docxVIP

/*郑州轻工业学院——————wuzhipeng*/ /*共有四个按键，K1 按下后时钟启动，K1 断开后可 以调表，其余三个按键分别调整时分秒，调整完毕按 下 k1 确认*/ #includereg51.h #includeintrins.h #define uchar unsigned char #define uint unsigned int uchar count=0,miao=0,fen=0,shi=0; uchar date[]={0xc0,0xf9,0xa4,0xb0,0x99,0x92,0x82,0xf8,0x80,0x90,0xff,0xbf}; uchar code wei[]={0x01,0x02,0x04,0x08,0x10,0x20,0x40,0x80}; int time[10]; sbit K1=P3^2; sbit K2=P3^3; sbit K3=P3^4; sbit K4=P3^5; bit K1flag=0; void delay(uint xms) { uint i,j; for (i=xms;i0;i--) for(j=115;j0;j--); } void display() { time[0]=miao%10; time[1]=miao/10; time[2]=11; time[3]=fen%10; time[4]=fen/10; time[5]=11; time[6]=shi%10; time[7]=shi/10; P2=wei[0]; P1=date[time[0]]; delay(1);//??? P2=wei[1]; P1=date[time[1]]; delay(1);//??? P2=wei[2]; P1=date[time[2]]; delay(1);//??? P2=wei[3]; P1=date[time[3]]; delay(1);// P2=wei[4]; P1=date[time[4]]; delay(1);// P2=wei[5]; P1=date[time[5]]; delay(1);// P2=wei[6]; P1=date[time[6]]; delay(5);// P2=wei[7]; P1=date[time[7]]; delay(1);// } void KeyProcess () //键盘处理程序 { display(); if(K2==0) { delay(10) ; if (K2==0) { while (!K2); shi++; if (shi==11) shi=0; //小时调整 } } if(K3==0) { delay(1) ; if (K3==0) { while (!K3); fen++; if (fen==11) fen=0;//分钟调整 } } if(K4==0) { delay(1) ; if (K4==0) { while (!K4); miao++; if (miao==11) {miao=0; }//秒调整 } } } void main () { TMOD=0x01; TH0=0x4c;TL0=0x00; EA=1;ET0=1; TR0=0; while (1) { if(K1==0) {TR0=1; display(); } else { TR0=0; KeyProcess (); } } } void timer0() interrupt 1 using 0 //中断程序 { TH0=0x4c;TL0=0x00; count++; if(count==20) { count=0; miao++; } if(miao==11) { miao=0; fen++; if(fen==11) { fen=0; shi++; if(shi==11) { shi=0; } } } }