智能钥匙系统.ppt

Oscillators for 钥匙 detection : each door, inside / outside luggage and front/ rear in cabin Detection area: approximately 0.7 to 1.0 m from oscillator Basic operation: Oscillator from vehicle outputs command signal to 钥匙 (134 kHz) After receiving the command signal, 钥匙 sends IDs to 遥控车门锁接收器 (wireless ID or Immobiliser ID)(-A: 314.35 MHz, -W, -V: 433.92 MHz, Korea: 312.15 MHz, China, Hong Kong: 315.12 MHz) Door Unlock Function: Oscillator regularly outputs the trigger signal through 天线 in 车门外部扶手. If 钥匙 enters the detection area, receive the trigger signal and sends ID code to 遥控车门锁接收器 天线 System moves to unlock stand-by mode. Door is unlocked by 触摸传感器 detection signal. 车门锁止功能: Trigger is pushing of lock SW. Door oscillator sends the signal through 天线 in 车门外部扶手 to 钥匙 when lock SW pushing 钥匙 sends ID code to 遥控车门锁接收器 天线 钥匙 location is checked at the same time (system checks signal output from 钥匙 by which trigger signal of oscillator) Door is locked Luggage Door Open Function: Trigger is pushing of the 行李箱盖开关 Trunk inside/outside oscillator, 内部发射器 (Front/rear) send the signal Smart 钥匙 receive signal and output ID code to 遥控车门锁接收器 天线 ID code and Smart location is checked (system checks signal output from smart by which trigger signal of oscillator) Luggage door lock is released Engine Start Function: Trigger is pushing of the 发动机起动开关 (电源控制ECU checks whether or not the brake pedal is depressing) 内部发射器 (with 天线) sends trigger signal when switch pushing 钥匙 receives this signal and output ID code to 遥控车门锁接收器 天线 验证 ECU checks ID code and 钥匙 location as in cabin (system checks signal output from 钥匙 by which trigger signal of oscillator) 验证 ECU sends 转向锁止 release order to 转向锁止ECU 转向锁止ECU checks ID of 验证 ECU via 识别码存储器 and release 转向锁止 验证 ECU sends imobilizer unset order to 发动机ECU (ECM) after checking the 转向锁止 is released Power source ECU sends engine start order after checking the 转向锁止 is released The 发动机起动开关 indicator blinks an amber color, when the DTC B2271, B2272,