c871-95中文版-用于可浸出氯化物、氟化物、硅酸盐及钠离子的绝热材料的化学分析标准试验方法.docVIP

C 871 PAGE 399 Designation: C 871 – 95编号：C871–95 PAGE 398 Standard Test Methods forChemical Analysis of Thermal Insulation Materials forLeachable Chloride, Fluoride, Silicate, and Sodium Ions These test methods are under the jurisdiction of ASTM Committee C-16 on Thermal Insulation and are the direct responsibility of Subcommittee C16.31 on Chemical and Physical Properties.Current edition approved June 15, 1995. Published August 1995. Originally published as C 871 - 77. Last previous edition C 871 - 94.本规范由ASTM委员会C-16 These test methods are under the jurisdiction of ASTM Committee C-16 on Thermal Insulation and are the direct responsibility of Subcommittee C16.31 on Chemical and Physical Properties. Current edition approved June 15, 1995. Published August 1995. Originally published as C 871 - 77. Last previous edition C 871 - 94.本规范由ASTM委员会C-16隔热材料委员会管辖并由C16.31化学和物理性能分委会直接负责。现行版本于1995年6月15日批准，并于1995年8月出版。最初版本编号为 This standard is issued under the fixed designation C 871; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A superscript epsilon (ε) indicates an editorial change since the last revision or reapproval.本标准以固定编号C871刊发；紧随编号后的数字表示最初采用的年份，或者是修订版的最后修订年份。圆括号中的数字表示最新重新批准的年份。上标(ε)表示自上一修订版或重新批准后的编辑性修改。 1. Scope适用范围 1.1 These test methods cover laboratory procedures for the determination of water-leachable chloride, fluoride, silicate, and sodium ions in thermal insulation materials in the parts per million range.这些试验方法涵盖了绝热材料中可浸出氯化物、氟化物、硅酸盐及钠离子含量（以百万分率计算）的实验室测定程序。 1.2 Selection of one of the test methods listed for each of the ionic determinations required should be made on the basis of laboratory capability and availability of the required equipment.从所列举的试验方法中选择测定各离子时需采用的相应方法应取决于实验室能力，以及是否具备所需设备。 1.3 This standard does not purport to address all of the safety concerns, if any, associated with it