c913-98中文版-预制混凝土水结构和污水结构的标准规范.docVIP

C 913 PAGE 594 Designation: C 913 - 98 编号：C 913 - 98 PAGE 593 Standard Specification forPrecast Concrete Water and Wastewater Structures This specification is under the jurisdiction of ASTM Committee C-27 on Precast Concrete Products and is the direct responsibility of Subcommittee C27.30 on Water and Wastewater Containers.本规范由ASTM委员会C-27预制混凝土制品委员会管辖，并由 This specification is under the jurisdiction of ASTM Committee C-27 on Precast Concrete Products and is the direct responsibility of Subcommittee C27.30 on Water and Wastewater Containers.本规范由ASTM委员会C-27预制混凝土制品委员会管辖，并由C27.30水和污水容器分委会直接负责.Current edition approved Dec. 10, 1998. Published February 1999. Originally published as C 913 - 79. Last previous edition C 913 - 96.现行版本于1998年12月10日批准，并于1999年2月出版。最初版本编号为 This standard is issued under the fixed designation C913; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A superscript epsilon (ε) indicates an editorial change since the last revision or reapproval.本标准以固定编号C 913刊发；紧随编号后的数字表示最初采用的年份，或者是修订版的最后修订年份。圆括号中的数字表示最新重新批准的年份。上标(ε)表示自上一修订版或重新批准后的编辑性修改。 This standard has been approved for use by agencies of the Department of Defense.本标准已获得批准供（美国）国防部各部门使用。 1. Scope适用范围 1.1 This specification covers the recommended design requirements and manufacturing practices for monolithic or sectional precast concrete water and wastewater structures with the exception of concrete pipe, box culverts, utility structures, septic tanks, and items included under the scope of Specification C 478.本规范涵盖除混凝土管、箱形涵洞、公共设施结构、化粪池和规范C478范围下包含的项目以外的整体式或组合式预制混凝土水结构和污水结构的推荐设计要求和制造规范。 Note 1—Water and wastewater structures are defined as solar heating reservoirs, cisterns, holding tanks, leaching tanks, extended aeration tanks, wet wells, pumping stations, grease traps, distribution boxes, oil-water separators, treatment plants, manur