c946-91中文版-干式堆积的表面粘结的墙的构造的标准规范.docVIP

C 946 PAGE 624 Designation: C 946 - 91 (Reapproved 1996) ε1 编号：C946-91（于1996年重新批准）ε1 PAGE 623 Standard Practice forConstruction of Dry-Stacked, Surface-Bonded Walls This practice is under the jurisdiction of ASTM Committee C-12 on Mortars for Unit Masonry and is the direct responsibility of Subcommittee C12.06 on Surface Bonding.本规范归ASTM负责砌块用灰浆的 This practice is under the jurisdiction of ASTM Committee C-12 on Mortars for Unit Masonry and is the direct responsibility of Subcommittee C12.06 on Surface Bonding.本规范归ASTM负责砌块用灰浆的ASTM C-12委员会管辖，并由负责路面砌合的C12.06小组委员会直接负责。 Current edition approved September 15, 1991. Published November 1991. Originally published as C 946 - 81. Last previous edition C 946 - 84 (1989).现行版本于1991年9月15日批准，并于1991年11月出版。最初版本编号为C946-81，上一版本编号为C946-84（1989）。 This standard is issued under the fixed designation C 946; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A superscript epsilon (ε) indicates an editorial change since the last revision or reapproval.本标准以固定编号C946刊发；紧随编号后的数字表示最初采用的年份，或者是修订版的最后修订年份。圆括号中的数字表示最新重新批准的年份。上标(ε)表示自上一修订版或重新批准后的编辑性修改。 ε1 Note—Keywords were added editorially in November 1996.ε1注—关键词于1996年11月份进行了编辑性添加。 1. Scope适用范围 1.1 This practice covers material, workmanship, and construction procedures for applying surface bonded mortar to both sides of dry stacked concrete masonry units. It does not include grout, reinforcing, anchorage, or control joints since their use is essentially the same as conventional concrete masonry construction, unless specifically mentioned in this practice.本规范涉及将表面粘合灰浆应用于干式堆积的混凝土砌块的两面的材料、工艺及施工程序。 Note 1—Design and construction procedures for conventional concrete masonry construction have been written by the American Concrete Institute, Building Code Requirements for Concrete Masonry Structures and the National Concrete Masonry Assoc