c952-91中文版-砌块用灰浆的粘结强度的标准试验方法.docVIP

C 952 PAGE 644 Designation: C 952 - 91 (Reapproved 1997)ε1 编号：C952-91（1997年重新批准）ε1 PAGE 631 Standard Test Method forBond Strength of Mortar to Masonry Units This test method is under the jurisdiction of ASTM Committee C-12 on Mortars for Unit Masonry and is the direct responsibility of Subcommittee C 12.02 on Research and Methods of Test. Committee E-6 maintains a continued interest in these practices and will make use of them in the future. This test method is under the jurisdiction of ASTM Committee C-12 on Mortars for Unit Masonry and is the direct responsibility of Subcommittee C 12.02 on Research and Methods of Test. Committee E-6 maintains a continued interest in these practices and will make use of them in the future.本试验方法归ASTM委员会C-12砌块用灰浆委员会管辖，并由C12.02研究和试验方法分委会直接负责。E-6委员会对这些标准规程一直有兴趣并将在未来使用这些规程。 Current edition approved April 15, 1991. Published June 1991. Originally published as E 149 - 59 T. Redesignated C 952 - 76 in 1981. Last previous edition C 952-86.现行版本于1991年4月15日批准，并于1991年6月出版。最初版本编号为E149-59T，1981年重新编号为C952-76， This standard is issued under the fixed designation C 952; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A superscript epsilon (ε) indicates an editorial change since the last revision or reapproval.本标准以固定编号C952刊发；紧随编号后的数字表示最初采用的年份，或者是修订版的最后修订年份。圆括号中的数字表示最新重新批准的年份。上标(ε)表示自上一修订版或重新批准后的编辑性修改。 This specification has been approved for use by agencies of the Department of Defense.该标准已经批准被美国国防部机构使用。 ε1 Note—Section 13 on Keywords was added editorially in November 1997.ε1 注——1997年11月编辑性地添加了关于关键词的第13节。 1. Scope 适用范围 1.1 This test method provides two procedures for measuring bond strength of mortar to masonry units: a crossed brick couplet tensile test for evaluating mortar-brick bonding and a stacked-bond, flexural test for evaluating mortar- concrete block bonding.本试验方法提供了两个