c947-97中文版-薄截面玻璃纤维钢筋混凝土挠曲特性的标准试验方法（用支梁三点载荷法）.docVIP

C 947 PAGE 627 Designation: C 947 - 97编号：C 947 - 97 PAGE 626 Standard Test Method forFlexural Properties of Thin-Section Glass-Fiber-ReinforcedConcrete (Using Simple Beam With Third-Point Loading)1薄截面玻璃纤维钢筋混凝土挠曲特性的标准试验方法（用支梁三点载荷法） This test method is under the jurisdiction of ASTM Committee C-27 on Precast Concrete Products and is the direct responsibility of Subcommittee C27.40 on Glass Fiber Reinforced Concrete Made by the Spray-Up Process.本规范归ASTM负责预制混凝土制品的C-27委员会管辖，并由C 27.40通过喷涂程序制成的玻璃纤维钢筋混凝土分委会直接负责。 Current edition approved June 10, 1997. Published March 1998. Originally published as C 947-81. Last previous edition C 947-89 (1996).现行版本于1997年6月10日批准，并于1998年3月出版。最初版本编号为C 947-81，上一版本编号为C 947-89（1996）。 This standard is issued under the fixed designation C 947; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A superscript epsilon (ε) indicates an editorial change since the last revision or reapproval.本标准以固定编号C 947刊发；紧随编号后的数字表示最初采用的年份，或者是修订版的最后修订年份。圆括号中的数字表示最新重新批准的年份。上标(ε)表示自上一修订版或重新批准后的编辑性修改。 1. Scope适用方法 1.1 This test method covers determination of the flexural ultimate strength in bending and the yield strength of glass-fiber reinforced concrete sections by the use of a simple beam of 1.0 in. (25.4 mm) or less in depth using third-point loading.本试验方法涵盖了通过支梁三点载荷法来测定玻璃纤维钢筋混凝土构件弯曲时的极限抗压强度及抗屈强度，其中使用的支梁深度小于或等于1.0英寸（25.4毫米）。 1.2 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.以英制单位表示的数值视为标准值，圆括号内的数值仅供参考。 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.本标准并非旨在解决所有与标准使用相关的安全问题（如有）。本标准