d3752-98中文版-水泥体中石棉强度的标准试验方法.docVIP

D 3752 PAGE 1045 Designation: D 3752 – 98编号：D 3752–98 PAGE 1044 Standard Test Method forStrength Imparted by Asbestos to a Cementitious Matrix This test method is under the jurisdiction of ASTM Committee C-17 on Fiber-Cement Products and is the direct responsibility of Subcommittee C17.03 on Asbestos-Cement Sheet Products and Accessories.本试验方法由ASTM This test method is under the jurisdiction of ASTM Committee C-17 on Fiber-Cement Products and is the direct responsibility of Subcommittee C17.03 on Asbestos-Cement Sheet Products and Accessories.本试验方法由ASTM委员会C-17纤维水泥制品委员会管辖，并且由C17.03石棉水泥薄板制品和附件分委会直接负责。 Current edition approved Aug. 10, 1998. Published March 1999. Originally published as D 3752 - 79. Last previous edition D 3752 - 90 (1995).现行版本于1998年8月10日批准，并于1999年3月出版。最初版本编号为D 3752-79 This standard is issued under the fixed designation D 3752; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A superscript epsilon (ε) indicates an editorial change since the last revision or reapproval.本标准以固定编号D 3752刊发；紧随编号后的数字表示最初采用的年份，或者是修订版的最后修订年份。圆括号中的数字表示最新重新批准的年份。上标（ε）表示自上一修订版或重新批准后的编辑性修改。 1. Scope 适用范围 1.1 This test method covers the measurement, on a laboratory scale, of the contribution of asbestos fibers to the strength of asbestos-cement products. The results obtained are used in the primary assessment of different fiber grades prior to their application on a larger scale.本试验方法涵盖实验室规模的石棉水泥制品中石棉纤维强度的测量。获得的试验结果用于更大规模使用前初步评估不同的纤维等级。 1.2 This test method covers the determination of the modulus of rupture (MR), adjusted to a dry density of 1.60 Mg/m3 (MRA), of asbestos-cement test specimens that contain the asbestos fiber to be evaluated at a concentration of 10 mass %, whereby the degree of fiberization of that fiber is specified in terms of specific surface area as determined by Test Method D 2752. The relative