e96-95中文版-材料水蒸汽渗透性标准试验方法.docVIP

E 96 PAGE 832 Designation: E 96 – 95 编号：E 96-95 PAGE 829 Standard Test Methods forWater Vapor Transmission of Materials These test methods are under the jurisdiction of ASTM Committee C-16 on Thermal Insulation and are the direct responsibility of Subcommittee C16.33 on Thermal Insulation Finishes and Vapor Transmission.上述试验方法由ASTM委员会C-16绝热委员会管辖，并由C16. These test methods are under the jurisdiction of ASTM Committee C-16 on Thermal Insulation and are the direct responsibility of Subcommittee C16.33 on Thermal Insulation Finishes and Vapor Transmission.上述试验方法由ASTM委员会C-16绝热委员会管辖，并由C16.33绝热体表面材料和蒸汽传递分委会直接负责。 Current edition approved March 6, 1995. Published May 1995. Originally published as E 96 - 53 T. Last previous edition E 96 - 94.现行版本于1995年3月6日批准，并于1995年5月出版。最初版本为E 96-53。 This standard is issued under the fixed designation E 96; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A superscript epsilon (ε) indicates an editorial change since the last revision or reapproval.本标准以固定编号E 96刊发；紧随编号后的数字表示最初采用的年份，或者是修订版的最后修订年份。圆括号中的数字表示最新重新批准的年份。上标（ε）表示自上一修订版或重新批准后的编辑性修改。 This standard has been approved for use by agencies of the Department of Defense. Consult the DoD Index of Specifications and Standards for the specific year of issue which has been adopted by the Department of Defense.本标准已获得批准供（美国）国防部各部门使用。对于（美国）国防部采用的具体刊发年份，请查阅（美国）国防部规范与标准索引。 Note—Table I was corrected editorially and the year date was changed on March 6, 1995.注——于1995年3月6日对表I进行了编辑性修正并修改了日期。 1. Scope 适用范围 1.1 These test methods cover the determination of water vapor transmission (WVT) of materials through which the passage of water vapor may be of importance, such as paper, plastic films, other sheet materials, fiberboards, gypsum and plaster products, wood products, and plastics. The test methods are limited to specimens not over 11/4 in