e518-80中文版-砌块抗弯粘结强度的标准试验方法.docVIP

E 518 PAGE 1084 Designation: E 518 -80 (Reapproved 1993) ε1 编号：E 518–80（于1993年重新批准）ε1 PAGE 1083 Standard Test Methods forFlexural Bond Strength of Masonry These test methods are under the jurisdiction of ASTM Committee C-15 on Manufactured Masonry Units and are the direct responsibility of Subcommittee C15.04 on Research.此试验方法归ASTM负责砌筑砖筑单元制造的ASTM C-15委员会管辖，并由负责此研究的C15.04 These test methods are under the jurisdiction of ASTM Committee C-15 on Manufactured Masonry Units and are the direct responsibility of Subcommittee C15.04 on Research. 此试验方法归ASTM负责砌筑砖筑单元制造的ASTM C-15委员会管辖，并由负责此研究的C15.04小组委员会直接负责。Current edition approved Aug. 1, 1980. Published January 1981. Originally published as E 518-74. Last previous edition E 518-76. 现行版本于1980年8月1日批准，并于1981年1 This standard is issued under the fixed designation E 518; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A superscript epsilon (ε) indicates an editorial change since the last revision or reapproval.本标准以固定编号E 518刊发；紧随编号后的数字表示最初采用的年份，或者是修订版的最后修订年份。圆括号中的数字表示最新重新批准的年份。上标（ε）表示自上一修订版或重新批准后的编辑性修改。 This standard has been approved for use by agencies of the Department of Defense.本标准已获得批准供（美国）国防部各部门使用。 ε1 Note—Section 12 was added editorially in June 1993.ε1注—第十二条于1993年6月份进行了编辑性添加。 1. Scope 适用范围 1.1 These test methods cover determination of the flexural bond strength of unreinforced masonry assemblages. Two procedures are provided:这些试验方法涉及无钢筋砌块组合的抗弯粘结强度的测定。提供如下两个程序： 1.1.1 Test Method A—Simply supported beam with third- point loading.试验方法A—三点加载式支承单梁 1.1.2 Test Method B—Simply supported beam with uniform loading.试验方法B—均匀加载式支承单梁 1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are provided for information only.以国际单位制表示的值视为标准值，圆括号内给出的值仅供参考。 1.3 This standard does not purport to address