c90-98中文版-承重混凝土砌块的标准规范.docVIP

C90 PAGE 75 Designation: C90-98编号：C90-98 PAGE 74 Standard Specification forLoadbearing Concrete Masonry Units This specification is under the jurisdiction of ASTM Committee C-15 on Manufactured Masonry Units and is the direct responsibility of Subcommittee C15.O3 on Concrete Masonry Units and Related Units.本规范归ASTM负责砌筑砖筑单元制造的ASTM C-1S委员会管辖，并由负责混凝土砌筑砖筑单元及相关砖筑单元的C15.03小组委员会直接负责。Current edition approved Jan. 10, 1998. Published November 1998. Originally published as C 90 - 3 IT. Last previous edition C 90 - 97a. This specification is under the jurisdiction of ASTM Committee C-15 on Manufactured Masonry Units and is the direct responsibility of Subcommittee C15.O3 on Concrete Masonry Units and Related Units.本规范归ASTM负责砌筑砖筑单元制造的ASTM C-1S委员会管辖，并由负责混凝土砌筑砖筑单元及相关砖筑单元的C15.03小组委员会直接负责。Current edition approved Jan. 10, 1998. Published November 1998. Originally published as C 90 - 3 IT. Last previous edition C 90 - 97a.现行版本于1998年1月10日批准，并于1998年11月出版。最初版本编号为C90-31T，上一版本编号为C 90-97a。 This standard is issued under the fixed designation C 90; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A superscript epsilon (ε) indicates an editorial change since the last revision or reapproval. 本标准以固定编号C90刊发；紧随编号后的数字表示最初采用的年份，或者是修订版的最后修订年份。圆括号中的数字表示最新重新批准的年份。上标(ε)表示自上一修订版或重新批准后的编辑性修改。 This standard has been approved for use by agencies of the Department of Defense.本标准已获得批准供（美国）国防部各部门使用。 1. Scope*适用范围* 1.1 This specification covers hollow and solid (see 5.4 and 5.5) concrete masonry units made from portland cement, water, and mineral aggregates with or without the inclusion of other materials. There are three classes of concrete masonry units: (1) normal weight, (2) medium weight, and (3) lightweight. There are two types of concrete masonry units: (1) Type I, moisture-controlled, and (2) Type II, nonmoisture-controlled. Th