d2589-88中文版-石棉纤维的麦克涅特湿式分类的标准试验方法.docVIP

D 2589 PAGE 998 Designation: D 2589-88 (Reapproved 1997)编号：D 2589-88（1997年重新审批） PAGE 997 Standard Test Method forMcNett Wet Classification of Dual Asbestos Fiber This test method is under the jurisdiction of ASTM Committee C-17 on Fiber-Reinforced Cement Products and is the direct responsibility of Subcommittee C17.03 on Asbestos-Cement Sheet Products and Accessories.本规范由ASTM委员会C-17纤维增强混凝土 This test method is under the jurisdiction of ASTM Committee C-17 on Fiber-Reinforced Cement Products and is the direct responsibility of Subcommittee C17.03 on Asbestos-Cement Sheet Products and Accessories.本规范由ASTM委员会C-17纤维增强混凝土制品委员会管辖，并由C17.03石棉水泥薄板制品和附件分委会直接负责。 Current edition approved Oct. 31, 1988. Published December 1988. Originally published as D 2589 - 67 T. Last previous edition D 2589- 87.现行版本于1988年10月31日批准，并于1988年12月出版。最初版本编号为D 2589-67T，上一版本编号为D 2589-87。 This standard is issued under the fixed designation D 2589; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A superscript epsilon (ε) indicates an editorial change since the last revision or reapproval.本标准以固定编号D 2589刊发；紧随编号后的数字表示最初采用的年份，或者是修订版的最后修订年份。圆括号中的数字表示最新重新批准的年份。上标（ε）表示自上一修订版或重新批准后的编辑性修改。 1. Scope 适用范围 1.1 This test method covers the determination of the length distribution and fines content of milled asbestos fiber by wet classification employing the McNett fiber classifier.本试验方法涉及采用麦克涅特纤维分级器通过湿式分类测定精加工石棉纤维长度分布和细粒含量的程序。 1.2 The values stated in SI units are the standard. The inch-pound units shown in parentheses are provided for information only.以标准国际单位表述的数值视为标准值，圆括号内的数值仅供参考。 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitatio