（可修改）在线粒度检测.pptVIP

自控柜 标准系统配置 客户自定义输出接口 4-20mA etc 电缆接口 通讯单元 Wago PLC 气路控制 电源及保护装置 软件 - Malvern? Link RTSizer  RTSizer 实时数据趋势图 数据库 颗粒粒径分度 过程变量 批量检测平均值 仪器状态信息 Malvern Link 硬件控制和监控 产品选择 设备运行顺序 报告报警 安全等级设定 RTSizer V7.20 实时信号处理 实时粒径数据显示 基于米氏理论 多种散射 专利技术 Malvern独享 国际论证 21CFR 实时历史数据文件 实时校正 系统自动诊断 粒径历史数据 3-面板 2 记录 1 历史 最多6个过程值显示 显示某一时间点测量值 平均记录值 课件 课件 课件 Before any particles pass through the laser beam, the detector signal (Background) signal should be recorded. This signal will be subtracted from the total scattering signal when particle measurements are being made so that the information reported (Particle size distribution results) only come from the signal generated by the light scattered by the particles The laser beam (Reported as Ring 0 on the left side of the Insitec display) is measured and set to be 100% light transmission. When particles are present in the laser beam, some of this light is scattered by the particles and the amount (or volume) of light recorded at Ring 0 is reduced. The transmission value is important to report the apparent particle loading which must be carefully controlled for all laser diffraction based systems. If the particle loading is too high, Multiple scattering events will increase and cause a smaller particle size to be reported. On Insitec this is avoided using the multiple-scattering correction. 课件 在前方衍射侦测器上的激光衍射图形是同心圆。 课件 课件 Larger particles scatter light at a small angle from the axis of the laser beam, and smaller particles scatter light at a larger angle from the axis of the laser beam. So, by placing photo-detectors at known angles from the axis of the laser beam, we can measure the angular scattering and translate this into a particle size distribution of many particle size classes. Many particles can be present in the laser beam at the same time and many sizes of particles can be recorded at the same time. With Malvern’s Insitec systems we can report a new particle size distribution result every 250msecs (1/4 second) 课件 When no more