ANSYS Simplorer状态机介绍与直流电机开环控制电路.pdfVIP

ANSYS Simplorer状态机介 绍与直流电机开环控制电路 太 李岩冰 亚 世 安 出品 | Introduction to State Modeling Using DC Motor 2 • Invoke Simplorer, note a default project and design are inserted. 太 • This lab will reuse the rectifier developed in the previous lab. Load the previous “Rectifier.aetd” project using File-Open. This will bring the previous project 亚 “Rectifier” into Simplorer asshown below. 世 安 • Add a new project using File - New . Change the name of the new project to be “DC_Motor_states” as shown below. 出品 | Importing a Previous Design 3 • Select “Design1” and copy it (Ctrl + C), then select the Project “DC_Motor_states” and paste that design into this project (Ctrl + V) • The project “DC_Motor_states” should now have two designs (one named the default “Simplorer1” that was included when Simplorer was first invoked, and the “Design1” that was just copied and pasted) 太 亚 世 安 • Close out the “Rectifier” project by selecting it, then RMB - Close (DO NOT USE Delete – this would delete that project from the computer) • Delete the default “Simplorer1” design RMB - Delete, the project manager window should now appear as shown. File - Save 出品 | Adding Components for DC Motor 4 • Double click on “Design1” to