瓶口螺纹标准.pdfVIP

瓶口螺纹标准 Cap and Neck Finishes ? Screw thread cap sizes are generally expressed as two numbers. The first number refers to the cap diameter (in millimeters) and the corresponding Glass Packaging Institute (GPI)/Society of the Plastics Industry (SPI) finish diameter. ? The second number refers to the height and thread configuration of the closure or finish. Below is a selection of commonly used caps and finishes. S=Thread Start H=Finish Height T=Major Diameter E=Minor Diameter I= Hole Diameter T - Outside diameter of the continuous thread E - Outside diameter of the finish shaft excluding thread I - The inside diameter of the finish at the smallest possible point S - The distance between the top of the finish to the top of the thread L - The distance between the top of the finish to the top of the transfer bead?? (optional) H - Height from the top of the finish to the bottom where it intersects with the shoulder W - The thickness of the transfe