培训中心 一带一路双语服务 06 Axially loaded member.pptVIP

3. Detailing requirements Spacing should not be greater than 80mm and dcor/5, and should not be less than 40mm; Diameter: should not be less than d/4 and 6mm. Longitudinal rebar minimum ratio: Member type Minimum reinforcement ratio Compressive member Longitudinal bar of full section 500MPa 0.5 400MPa 0.55 300MPa, 335MPa 0.6 One side bar 0.2 One side bar of the member of bending, eccentric tension, axial tension Max(0.2, 45ft/fy) 4.Example 3-3 One circular section column, basic information: d=500mm, N=3900kN, l0=6m, C30, HRB400 for longitudinal rebar and HRB335 for spiral wire. Environment type I. Try to design the reinforcement bars according to axially compression member. * * * * * * * * 混凝土结构设计原理 Strength of RC axially loaded members Chapter aim Understanding full process of axially loaded members 了解轴心受拉构件和轴心受压构件的受力全过程； ? loading capacity calculation method 掌握轴心受拉构件和轴心受压构件正截 面承载力的计算方法； Chapter aim design method of axially loaded members 了解建筑工程轴心受力构件与公路桥涵 工程轴心受力构件设计计算方法的相同 与不 同之处； Detailing requirement of axially loaded members 熟悉轴心受力构件的构造要求 What is axially tensile member? What is axially compressive member? 理想的轴心受力构件在实际工程中其实并不存在。 Not exist in practice §3.1 Introduction 混凝土结构设计原理 §3.2 Axially tensile members 3.2.1 Resistance process and failure characteristic 3.2.2 Axially tensile members in building engineering 1. Calculation formula …3-1 N —— combination design value of tension； fy —— design value of tension strength of bar， fy ? 300N/mm2 ； As —— cross section area of the longitudinal bar 2. example 3-1 Tension design value N=700kN, HRB335. Try to design the longitudinal reinforcement bar. 3.2.3 Detailing requirements hoop bar: d≥6mm, space: s ≤200mm (web member腹杆s ≤150mm)。 longitudinal bar: symmetrically, evenly, surrounding; give priority to use of small diameter bar. Bar connection: normally binding, welding, bolt, sleeve compression (套筒挤压), but binding is not accepted for axi