MCD500Modbus通信说明英文版.pdfVIP

MCD Modbus Module Instructions Introduction INSTALLATION INSTRUCTIONS: MCD MODBUS MODULE Order Code: 175G9000 1. Introduction Danfoss soft starters can be controlled and monitored across an RS485 serial communication network using the Modbus RTU and AP ASCII protocols. For users requiring simple control of MCD 200 and MCD 500 soft starters using Modbus RTU or AP ASCII, the instructions below describe the installation and operation of the Modbus Module. MCD 3000 soft starters have AP ASCII protocol support built in - see the MCD 3000 Users Manual for details of message formats. The MCD 3000 supports Modbus RTU control when used in conjunction with a Remote Operator. This document describes Modbus and AP ASCII messaging and Appendix A describes how to connect the Remote Operator and use it as a Modbus RTU or AP ASCII slave device. 2. Installation 1. Remove control power and mains supply from the soft starter. 2. Attach the Modbus Module to the starter as shown. 3. Apply control power to the soft starter. MCD 200 MCD 500