flow3dprepin.inp常用参数详解剖析.docxVIP

$xput TWFIN ...Time to end calculation. Default is TWFIN=10.0 unless thermal cycling is activated (see Thermal Cycling Options). 计算结束时间，在热循环开启的情况下默认值为 10.0（参 考热循环选项） 计算完成时间 ITB ... Indicator for free surfaces or sharp interfaces =0, no free surface or sharp interface =1, free surface or sharp interface Defaults to 0 if IDRG 5; defaults to 1 if IDRG=5. 自由表面或粗糙界面的指示器 ＝0 表示二者都没有 ＝1 表示二者有其一 是否考虑熔汤表面与空气的影响 GY 0.0 Gravity component in y direction. See GRAVYin namelist MOTN for orientation varying gravity. Note: For cylindrical coordinates, use GRAVX, GRAVY. 考虑重力对压铸影响，注意 g 的方向且为 -980,单位为 CGS。 GRAVX 0.0 Initial x-direction component of gravity. 坐标系为极坐标时用上述参数 IFENRG ... Flag for internal energy evaluation =0, no energy solution =2, solve transport equation for internal energy (1st order advection) =3, solve energy transport equation using monotonicity preserving, second order method. Defaults to 0 if ICMPRS=0 and IHTC=0; defaults to 2 if ICMPRS=1 or IHTC0. 选择能量方程用于计算 1 ISHRNK 0 Solidification shrinkage flag. Shrinkage models may only be used for one-material problems (NMAT=1) when ITB=1. Solidification must be activated and solidified density ( ) must be different than liquid fluid #1 RHOFS density ( RHOF). Shrinkage cavitation pressure (PCAV) must also be set for Dynamic Shrinkage model. (PCAV, RHOFS and RHOF are in namelist PROPS.) =0, no shrinkage model =1, activate Dynamic Shrinkage model =2, activate Rapid Shrinkage model. 凝固收缩的定义： 0 表示不收缩。 IFVIS 0 Viscosity evaluation flag 熔汤层流状态 =0, local viscosity evaluation (no turbulence model) =1, Prandtl mixing length =2, turbulent energy model =3, two-equation (k- ) turbulence model =4, Renormalized Group Theory model (RNG) IFIN 1 Selects the basis for termination of the calculation =1, terminate when tTWFIN =2, terminate when fill fraction exceeds FRCFIN or no cells are empty or TTWFIN =3 terminate when solidified fraction exceeds FRCFIN or TTWFIN. 确定终止计算过程， 2 为以充填百分比为计算终止标准。 FRCFIN 1.0 Fill fraction (IFIN=2) or soli