m啤酒废水处理工艺设计--毕业设计.docVIP

长沙学院毕业设计 第 PAGE 4页 摘 要 本设计选用二段接触氧化法处理1200m3/d啤酒废水。原污水中各项指标为：BOD浓度为900mg/L,COD浓度为1800mg/L，SS浓度为400mg/L。要求处理后的排放水达到BOD=30mg/L、COD=100mg/L、SS=30mg/L。生物接触氧化法属于好氧生物膜法的一种，是在生物滤池的基础上，从接触曝气法改良演变而来的。它该工艺的特点是微 关键词：二段接触氧化法，生物接触氧化，啤酒废水 ABSTRACT The designed volume of input water is 1200m3/d, regardless of the specified future development. The Various targets of influent are as follows: BOD 600mg/L, COD 1800mg/L, SS 400mg/L. The outlet are demanded to reach BOD=30mg/L, COD=100mg/L, SS=30mg/L.Bio-contact aerobic oxidation is a biofilm, in the biological filter on the basis of contact aeration method evolved from the improvements. The characteristics of this design are high biomass.Need to fill in the attached growth, fillers can be fixed, can at irregular among floating or swimming. And wastewater and liquid filling the gap, and biofilm contacts and biological oxidation reaction, strongly bearing the impact load, no the sludge inflating phenomenon, conveniently operation. The oxidize contact pond enters the water and air from bottom. The waste water and the air enter the padding from the base, thus the padding is intensely shaked by the water and air current directly, which accelerates the renewal of biomembrane, makes it to maintain a higher activity Keywords：second contact oxidation ; Biologic contact oxidize treatment ; Beer waste water 目 录 第1章 工程背景 1.1项目概述………………………………………………………………………………1 1.2设计原则………………………………………………………………………………1 1.3工程建设规模及进出水水质…………………………………………………………1 1.4采用规范和标准………………………………………………………………………2 第2章 污水处理方案的确定 2.1印染废水的特征………………………………………………………………………3 2.2废水工艺选择…………………………………………………………………………3 2.3废水处理工艺流程……………………………………………………………………4 第3章 主要处理构筑物参数及计算 3.1格栅……………………………………………………………………………………6 3.2集水井…………………………………………………………………………………7 3.3调节沉淀池……………………………………………………………………………7 3.4一段接触氧化池………………………………………………………………………8 3.5中间沉淀池……………………………………………………………………………9 3.6二段接触氧化池 ……………………………………………………………………10 3.7二次沉淀池 …………………………………………