ppp协议封装、认证配置完美版.docx

计算机类课程实验报告 院/系：网络工程 课程名称：广域网技术 班级 姓 -名 学号 实验室号 日期 年 月曰 组号 计算机号 实验 名称 Ppp协议封装、认证配置 得分 情况 -一- -二二 三 四 五 六 成绩评定 实 验 内 容 要 求 实验内容：配置 ppp协议，配置 PPP协议的认证。  备注:本实验报告用于计算机类相关课程的实验 ，务必按时、按要求完成。不交此报告者，本次实验为不合格 基本配置: 实验主要 实验主 要 步 骤 与 配 置 内 容 Conf t Ho R1 Int s0/0 Ip add 12.1.1.1 255.255.255.0 No sh Encaps PPP End R2 Conf t Ho R2 Int s0/0 Ip add 12.1.1.2 255.255.255.0 No sh Encap PPP End 验证配置： R1#sho i nt s0/0 SerialO/O is up, li ne protocol is up Hardware is M4T In ternet address is 12.1.1.1/24 MTU 1500 bytes, BW 1544 Kbit, DL Y 20000 usec, reliability 255/255, txload 1/255, rxload 1/255 En capsulation PPP, LCP Ope n Open: IPCP, CDPCP, crc 16, loopback not set Keepalive set (10 sec) Restart-Delay is 0 secs Last in put 00:00:03, output 00:00:02, output ha ng never Last cleari ng of show in terface coun ters 00:05:56 In put queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0 Queue ing strategy: weighted fair 77 packets output, 3418 bytes, 0 underruns 0 output errors, 0 collisi ons, 1 in terface resets 0 output buffer failures, 0 output buffers swapped out 1 carrier tran sitio ns DCD=up DSR=up DTR=up RTS=up CTS=up (写不完时，可另附稿纸。 )| 实验主要 实验主 要 步 骤 与 配 置 内 容 SerialO/O is up, li ne protocol is up Hardware is M4T In ternet address is 12.1.1.2/24 MTU 1500 bytes, BW 1544 Kbit, DL Y 20000 usec, reliability 255/255, txload 1/255, rxload 1/255 En capsulation PPP, LCP Ope n Open: IPCP, CDPCP, crc 16, loopback not set Keepalive set (10 sec) Restart-Delay is 0 secs Last in put 00:00:20, output 00:00:08, output ha ng never Last cleari ng of show in terface coun ters 00:01:18 In put queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0 Queue ing strategy: weighted fair Output queue: 0/1000/64/0 (size/max total/threshold/drops) Con versatio ns 0/1/256 (active/max active/max total) Reserved Con versati ons 0/0 (allocated/max allocated) Available Ban dwidth 1158 kilobits/sec 5 minute in put rate 0 bits/sec, 0 packets/sec 5 minute output rate 0 bits/sec, 0 packets/sec