注塑机底座结构设计与振动分析外文文献翻译、中英文翻译、外文翻译.docVIP

IOP Conference Series: Materials Science and Engineering PAPER ? OPEN ACCESS Design and Vibration Analysis of Injection Moulding Machine Base Structure To cite this article: CH Kesava Manikanta Kumar et al 2021 IOP Conf. Ser.: Mater. Sci. Eng. 1128 012041 View the \h article online for updates and enhancements. This content was downloaded from IP address 42 on 11/05/2021 at 13:29 IConACES 2020IOP Conf. Series: Materials Science and EngineeringIOP IConACES 2020 IOP Conf. Series: Materials Science and Engineering IOP Publishing doi:10.1088/1757-899X/1128/1/012041 1128 (2021) 012041 Design and Vibration Analysis of Injection Moulding Machine Base Structure CH Kesava Manikanta Kumar1, K Annamalai*2, S Vinoth kumar3, Ponraj A4 1 PG Student, School of Mechanical Engineering, VIT University, Chennai- 600127, India. 2 Professor, School of Mechanical Engineering, VIT University, Chennai-600127, India. 3 Mechanical Engineer, Chennai 600127, India. 4 Mechanical Engineer, Chennai-600127, India. Email: 1 \h kesava4802@ *2 \h kannamalai@vit.ac.in 3 \h bosrevs@ 4 \h ponraj.alagesan@ Abstract. In this study the dynamic behaviour and vibration parameters of Injection Moulding Machine Base Structure was performed by analysing the structure numerically as well as experimentally. Modal analysis and FRF analysis performed numerically to find the mode pattern, natural frequencies and critical points. Vibration parameters are measured by performing experimentation using FFT analyser and the data was taken by using BK (Bruel kjaer) Connect software. The Fast Fourier Transform (FFT) analyzer is used to transform the continuous time domain data to continuous frequency domain data. The experimental results show that structure is vibrating high at clamping unit location along x-direction. Vibration level can be controlled at that particular location by increasing the stiffness of the structure. Keywords: Modal and FRF Analysis, FFT analyser, BK Connect. Introduction Injection mould