毕业设计PLC四层电梯内含组态王仿真程序.docx

word word 冲修编 冲修编 基于PLC电柳控制系统设计 摘要 目前电周控制系餌主要有三种控制方式：址电器控制系统、PLC控#系必 金机控制系卸。PLC控M系统由于远行可靠11髙，使用樂修月便，抗干 i?it Willi试囲UH枚也等优点，信堂人fl重袒，已成％目前在电怖控制系级中使用 最名的控找方式。 本文在阐速电H1的构苗和可编程控制器的耘适HII作feJftfl根厥上，『时4 民电冲，使用西D子S7-200可编程控制器,设计了电系级，包括轿内指 合和疗外召廳信号的登e与綺除、电棉的aiff定向、电将侗开关n运打、电格 上下行径找、电棉的布层控m等冏部，实周了册内与各层畔用指令的记录、电糊 运斤方向和il层的控制，电榆上下行和自动开关门、电将的指层控制等的能。同 时也使用了组态王6-53完収上位机目PLC控制电命的仿真。 关铤词：四层电*控iM系统可编程控甘器组咨王 PLC-based elevator control system design Abstract At present the elevator control system mainly has three control modes: Following electric circuit control system, PLC (Programmable Logic Controller) control system, microputer control system. PLC control system, because moves the reliability to be high, the use service is convenient, anti-jamming, the design and the debugging cycle is short and so on merits, time is taken seriously the people and so on merits, have bee present use most control modes in the elevator control system. This article elaborated the elevator structure t the structure and the working principle of the programmable logic controller Aim at the elevator of four floors, the writer design this elevator control system by the use of Siemens S7-200 programmable logic controller. The writer design the elevator control parts, such as, the part of register and cancel the instructions from the cabinf the part of register and cancel the instructions trom the station hall, the part of choose station and direction, the part of door movement, the part of elevator operationt the part of shown layer , and so on. These parts achieve the functions： registering the instructions from the cabin and the station halL choosing the direction and the station of elevator, elevator go up or down and door automatically, fingering out the location of the cabin, and other functions.Also use kingview 6.53 plete pc to pic control elevator simulation. Key Words: Four-story Elevator; Control System ;ProgrammableLogic Controller; kingview 目录 的耍I Abstract! I 弟一章绪论1 1.1电国内外开展状况1 1.2课通的研究背笊反意义2 P