ZH1105柴油机气缸体三面粗镗组合机床总体及右主轴箱设计.docVIP

PAGE PAGE 26 ZH1105柴油机气缸体三面粗镗组合机床总体及右主轴箱设计 摘要：本文主要内容是组合机床的设计过程。组合机床有很多特点，可以同时完成多种工序的加工，并且相对于传统机床具有：高效率、高精度、低成本的优点。组合机床的组成包括床身、立柱、工作台、及电源和一些基本部件和特殊部件构成。 当今组合机床能够加工的方法有很多，所能完成的加工工序也非常多本课题中组合机床主要要完成孔的加工任务以及一些平面的加工。具体内容如下： （1）、工艺方案的制定对加工零件的特点、精度以及定位夹紧方式作了解，以此来确定机床设计的工艺方案并且能够绘制出工序图。 （2）、总体设计确定个零件的具体要求，并作出适当的选取，计算相关生产率和轴的切削用量，并绘制计算出三图一卡相关内容。 （3）、组合机床部件设计主要关于多轴箱的设计，轴和轴承的选用是否合适，保证各部件都能够运行平稳。 关键词：组合机床；工艺特点；多轴箱 Overall and right main axle box design of ZH1105 diesel engine cylinder block three face rough boring machine tool Abstract：The main content of this paper is combination of machine design process. Modular machine tool has many characteristics can be while completing the processing of a variety of processes, and compared with traditional machine with: high efficiency, high precision, low cost advantages. The composition of the modular machine tool including bed, column, table, and power and some basic components and special components composition. Todays modular machine tool to there are a lot of processing method, the process is very much subject combination machine tool primarily to complete the hole processing tasks and some graphic processing. Specific content as follows:, (1)，Make process plan On the characteristics of the processing parts, precision and positioning of the clamping method for understanding, in order to determine the design of the machine tool design process and can draw the working procedure. (2),Overall design to determine the specific requirements of the parts, and make the appropriate selection, calculation of the relevant productivity and the amount of the axis of the cutting, and draw a figure of three drawing a card related content. (3),Modular machine tool parts design Mainly on the design of multi axle box, axis and bearing selection is appropriate, to ensure that all components are able to run smoothly. Keywords: Modular machine tool; process characteristics; multi axle box 1 绪论 1.1 研究意义 随着全球化的进程越来越快各行业的产业竞争也越发的激烈。决定产品竞争力有诸多因素，用户通常不只是追