船舶制造必备英语日常用语1000句.pdf

船舶制造英语日常用语 好东西大家分享啊 船舶制造英语日常用语 一． ? ? ? ? 船体 1．? ? ? ? You must weld and grind this area before painting. 在油漆之前你必须把这个地方电焊修补、打磨好。 ? 2 ．? ? ? ? This welding line should be gouged and welded again before tightness inspection. 这条焊缝在密性检查前要碳刨、再焊。 3 ．? ? ? ? The structure of the starboard side is different from the port side. 右舷的结构跟左舷的不一样。 4 ．? ? ? ? We should reinforce the downside of the windlass. 我们应该在锚机的反面加强。 5 ．? ? ? ? The navigation deck is not plain,? we will fair the deck by hot working. 驾驶甲板不平，我们要火工校正。 6 ．? ? ? ? There are two pieces of stiffeners and brackets must be replaced. 有两块加强筋和肘板要换新。 7 ．? ? ? ? Two more footrests and handgrips should be installed at the entrance of the small hatchcover. 在小舱口盖的进口处再安装两只踏步和拉手。 8 ．? ? ? ? Checking the joint accuracy and structure integrity between No.8 and No.9 block after closed. No.8 与 No9 分段合拢后大接头装配精确性和结构完整性检查。 9 ．? ? ? ? Checking structure integrity of superstructure(deckhouse)after welding. 上层建筑焊后结构完整性检查。 10．? ? ? ? Inspecting fitting accuracy of hatch coaming on board. 货舱口围板船上安装精度检查。 11．? ? ? ? Inspection air pressure test(with water head) for No1. water ballast tank(No15 block). No1 压载水舱（ No.15 分段）气压试验（压头试验）检查。 12．? ? ? ? Inspection hosing test for upper deck. 上甲板冲水试验检查。 13．? ? ? ? Measuring hull ’s main dimensions: length overall(LOA.),length between perpendiculars(LPP.),breath molded(B.),depth molded(D.) and deflection before launching. 下水前测量船体主尺度：总长、两柱间长、型宽、型深、基线挠度。 14．? ? ? ? Inspection distance between draught marks and keel plate after marking out. 划线后检查吃水标尺至平板龙骨之间的距离。 15．? ? ? ? Inspecting fitting accuracy of draught mark(loading line mark). 吃水标志（载重线标志）安装精确性检查。 16．? ? ? ? Inspection welding seam and dimension of cargo hatch cover. 货舱舱口盖焊缝和尺度检查。 二． ? ? ? ? 轮机 1．? ? ? ? Inspection machining dimension of propeller shaft(intermediate shaft or counter shaft). 螺旋桨轴（中间轴）机加工尺寸检查。 2 ．? ? ? ? Check for surface contact area(