第3章 单区域OSPF协议及其配置方法.pptVIP

● 3.7 验证OSPF的运行 例3-11 “show ip ospf interface”命令的输出例 R2#show ip ospf interface e0 Ethernet0 is up, line protocol is up Internet Address 192.168.0.12/24, Area 0 Process ID 1, Router ID 192.168.0.12, Network Type BROADCAST, Cost: 10 Transmit Delay is 1 sec, State DROTHER, Priority 1 Designated Router （ID） 192.168.0.11, Interface address192.168.0.11 Backup Designed router （ID） 192.168.0.13, Interface address192.168.0.13 Timer intervals configured, Hello 10, Dead 40, Wait 40, Retransmit 5 Hello due in 00:00:04 Neighbor Count is 3, Adjacent neighbor count is 2 Adjacent with neighbor 192.168.0.13 （Backup Designated Router） Adjacent with neighbor 192.168.0.11 （Designated Router） Suppress Hello for 0 neighbor（s） ● 3.7 验证OSPF的运行 ●“show ip ospf”命令显示出所执行过的SPF算法的次数。 ● 3.7 验证OSPF的运行 例3-12 “show ip ospf”命令输出例 p1r3#show ip ospf Routing Process “ospf 200” with ID 172.26.1.49 Supports only single TOS（TOS0） route SPF schedule delay 5 secs, Hold time between two SPFs 10 secs Minimum LSA interval 5 secs. Minimum LSA arrival 1 secs Number of external LSA 0. Checksum Sum 0×0 Number of DCbitless external LSA 0. Number of DoNotAge external LSA 0. Number of areas in this router is 1. 0 normal 1 stub 0 nssa Area 1 Number of interfaces in this area is 2 It is a stub area Area has no authentication SPF algorithm executed 6 times Area ranges are Number if LSA 7. Checksum Sum 0×25804 Number of DCbitless external LSA 0 Number of indication LSA 0 Number of DoNotAge LSA 0 ● 3.7 验证OSPF的运行 ●“show ip ospf neighbor”命令可按接口显示OSPF邻居信息，即 show ip ospf neighbor [type number][neighbor-id][detail] “show ip ospf neighbor”命令 描述 type （任选项）接口类型 number （任选项）接口号 neighbor （任选项）邻居的ID detail （任选项）所有邻居的详细显示（列出所有邻居） 表3-7 show ip ospf neighbor”命令 ● 3.7 验证OSPF的运行 例3-13 在以太网拓扑结构中的“show ip ospf neighbor”命令输出例 例3-14 在点对点网络中的“show ip ospf neighbor”命令输出例 Routershow ip ospf neighbor Neighbor ID Pri State Dead Time Address Interface 192.168.0.13 1 2